Recent content by neverfinished

i destroyed my 7 1/4 rear and need something a little tougher, i need an a complete 8 1/4, or for 8 3/4 i need a housing and axles, and large bolt or small bolt pattern would be fine. Also, i live in st. Louis and would like to be able to drive within a couple hours to pick it up, thanks

super stocks sit about 2" above stock i'm told

i need 4.5" bolt pattern 10" x 2 1/2" rear drums for an 8 3/4 rear end, i need the drums, backing plates, and hardware, if anyone has them or knows a good place to get them please let me know thanks Mike

also if you want to switch to a lighter aluminum radiator you can get one from summit racing, they should have a direct fit or a cheaper universal fit, if you do the universal pay attention to which side the inlet and outlet are on, also these require a seperate trans cooler

my 8 3/4 sure grip rear is leaking, i am going to install a new gasket and just kind of check that i still have all the teeth on my gears, what else would be good for me to check while i have it apart, and also what fluid should i use for the differential, and how much?

hopefully later i can find some pics of mine, but for now i will tell you it looks really good, i had a demon side stripe on mine which although it wasnt correct just made the car look amazing

i really don't think they would name it a demon, for one they dont seem at all alike, demons weren't even offered in convertable which alone makes the idea stupid, but number 2, the demon only lasted a few years because their was so much bad press due to the name of the car, this is why demons...

i have rims that are 14 x 9 3/4, and so i need tires in the area of 275 or larger but i'm having trouble finding any for a 14 inch rim, my car is a street car and i dont really want something as soft as mickey thompsons, but its all i can find, does anyone know of any other options? aside from...

i have seen what you were refering to, and no pics were posted sadly, from what i was reading i get the idea that an H shaped bracket was used so that it could be bolted to the frame rather then welded, i however would like to see pics of this as well, i had heard however that there are issues...