Recent content by OG67DartGTC

I know how that is!! :lol:

Absolutely! The ones I have now are pretty baked, but they still work, although, it would not be a bad idea to have another set on hand…just sayin’! I will definitely PM you in the very near future to make that happen!

The worst thing is if it too expensive, I can just “pass”, but I would like to see where he got the correct hinges from so I can source it if possible. I talked with PG Classics and they only sell the same hinge I have right now, even though they have the same type of replacement lid with no...

Unfortunately no. The hinge rod has tails on both ends that are bent over the sides to keep it from slipping out from vibration and use. Also, the rod is some type of spring steel and doesn’t like to bent and twisted too many times before it snaps. One would think if this is what is being made...

Where can I get the spring loaded version that keeps the lid closed? The hinge I have keeps the door open…

I tried reversing the spring and that didn’t work…Too late for me to return them but I will look into these places for help! Thank you!

Would you by any chance know where I can get a spring hinge that is the reverse of what I have? The hinge I have will only go one way and it hold the door open, not closed, hence the button latch to hold it down…any advice is appreciated!

When my dad bought the car I didn’t realize it had ‘69 seats, center console, or original 273 motor. When I ordered all my parts for the console plates, I ordered them for the ‘67, not for the ‘69, and the fitment is just like the original console lid and console door, except for hinge and...

Thank you sir and will do!

I was hoping not to have to do that, but can use some stainless allen or torque screws to make it as clean as possible, or I can release the spring tension of the hinge and use heavy latch magnets to keep the lid from rattling and stay secured while going down the road with the top down. I also...

100% agree, but I also asked and investigated on their website about the 69-76 and none of the new lids have the latch, latch hole or the embossing for the latch…

Hey all, first I hope y'all have an awesome Thanksgiving. Issue and question on the center console compartment lid: I bought a center console replacement top plate and the compartment top as well from Classic Industries (CI). My old compartment lid has a button latch, but the new compartment lid...

I appreciate y’all for the advice and suggestions. I will, most certainly, take all the comments under advisement on how I am going to proceed…thanks again!

Lol…nope. I just found it odd the oil pan was closer to the ground than the K-member, but as I stated above, I’m new with Mopars and was just asking for advice on possibilities and the clearances. If I have to, I’ll fab a sheet metal skid plate to protect it. Apparently, I was mistaken in my...

Thanks for the advice…