'Cuda is apart. Most of the primer work is done. Next is some sheet metal work. Once that is done, paint. Motor is going to be refreshed since it is out of the car.
Update on the 'cuda. Found the dog dish hubcaps. Put on a Edelbrock carb, but have the 4611 which will go back on the car. Had a spare Hurst shifter rebuilt and will be installed. There needs to be some other mechanical work done, brakes for one, nothing real major
'cuda is at S&S...
After much searching, spending money, the problem was a bent water pump pulley. The vibration disappeared once that was replaced. Live and learn!
Pa karp
Pulled the carb, it was fine. Replaced the orange ignition box with the blue one. Engine idles rough and will not idle below 1000 rpm. Timing is set at 12 degree initial. Above 1500 rpm the car pulls hard in all 4 gears. when I shut the engine off, it will diesel. When the car dies at...
I have an issue with my 340 4 speed. The engine has developed a low speed stumble. It seems to run fine at high way speed.
I have replaced the coil and distributor cap. The ignition has been converted to electronic ignition.
I checked one of the spark plugs, it looks to have normal...