Recent content by PCP71Demon

I live in Ontario Canada and bought mine from NAPA Autoparts. Complete cable assembly that just fit as per OEM and it was $34.95 + 13% Ontario tax. Thinking any autoparts store could get it. Good Luck

Thanks to everyone for your help and direction. Stopped back at tranny shop and they don't have the needed 37 tooth gear in stock....but are going to source me one. Thanks to all for input and responses.

Locomotion, Thankyou very much for all the info and chart. Helps a lot. Appreciated! Stopped back at the tranny shop and they don't have one (37 tooth) in stock, but will look to sorce one for me. Thanks

Thanks....Appreciate the help. Shims are in correctly, thicker section to the rear. so if my tranny is 2.1 degrees down, my diff angle needs to be 4 negative?? if so thinking a 6 degree any shim, replacing the 4 degree, should put me close ? Thanks again for all the help.

Thanks to all the responses. Appreciated ! My shims are in the way the pics above show. Thicker section to the rear. Thinking perches are not well located from previous owner. From the responses i gather that my diff front yoke should be angled down, not up the 2.8 degrees, based on all other...

Hey All, Need some help/clarification on next steps for setting the pinion angle on my 71 Demon. Car had a 904 transmission, which was swapped out for a 727 after the 904 got destroyed. with the 727 being a couple inches longer i had to get a new driveshaft. I also installed a new rear...

Hey All, Had a new transmission put in my 71 Demon, upgrading from a 904 transmission to the 727. My speedometer is now out about 10 MPH high at 40 MPH. So, thinking either the internal speedometer gear of the transmission is a different tooth count or the car shop that changed out the...

Hey, THANKS GSXcite for your response. Measured the length of the one coupler today and its about 3" long, the rough length of one of the aftermarket extensions from Summit Racing, Classic Industries etc, that you stated. my thought of the car having a power steering to manual conversion and...

Hey Guys, Great info and forum...Thankyou ! I bought a 71 Demon about 1.5 years ago and not sure what is going on, but I have 2 of those steering couplers welded end2end to make up the distance needed from the end of the steering column to the manual steering box. Also end of steering column...

Hi All, Nice to see a website devoted to "A" bodies. Looking forward to having conversations with everyone and gaining some knowledge. Have been out of the Mopar classic car seen for close to 40 years due to "life in general". Purchased the attached 1971 Demon, late last fall, so looking forward...

Hey All, New to site and still learning navigation within. Looking forward to communicating with all the Mopar people and their vast knowledge....as I have lots to learn. Thanks

Moparwedden, I am new to the site today, and recently picked up a 1971 Demon. See you are from Trenton Ontario. I am in Belleville, Ontario. Looking forward to info from the site as I start to attend car shows and tinker with my car. Thanks