Recent content by pest1688

Thanks a lot guy's your always so much help!

Hi how hot should my engine be running. my 318 runs at 180 to 190 with ac off and 190 to 200 a/c on when temp outside is 80. I notice it runs hotter 190 on the hywy and around town 175 to 180. Are these numbers acceptable? Thanks!!

thank you that was very helpful it's all hooked up and running great

Hi I'm hopeing some one can help. i'm not sure what to do with the blue wire for the Two Step Rev Control. do I even need it? the wire from the key to turn on & off the ingnition box can i just use that and twist the blue and red wires together then connect it back to the ingnition (key). I put...

HI i'm hopeing someone can tell me if i wired this right. The box itself was very simple to wire my question is the ignition wire or wire's that turns on the MSD box there is two of them I looked in my repair manual there's position 1 (start) and position two (run) if i dont connect both wires...

Yeah changeing the pick up seemes like a good idea so i just replaced the whole distributor and the problem still exsisted it even seemed to get worse. That distributor was old and cheap looking I was going to replace it any way. Msd box is on it's way back to dealer for exchange. Could the pick...

Well I figured it out the MSD box is faulty. It goes on and off. I checked the ignition wire that turns it on and off with mt test light and it stays lite when the box is off. So it has to be the box right.

It was doing this with the old carb on it too. When it did it today I qiuckly checked for spark and there was no spark when about 5 min went by it started right up It's a new coil MSD new ignition box MSD. Do you think it's the distributor or a defective MSD box? when I first cranked it after it...

Hi I have a 1970 Dodge Swinger with a 318 & new Holley 650. This is a strange problem I'm haveing here and I hope one of you can help me with it. After the car has warmed up It will stall. It will only do this when I'm idleing at a light or when I'm comeing to a stop but it only seems to do it...

Hi my first time here. I was hoping someone can tell me how to adjust my front windows it's closed at the bottom but as it goes up to the top it starts to bend outward so the glass is pulling outward from the weather stripping. There's like a 1/2 inch space where water can get in. Any idea's on...