Checked for cracks
Gasket Match
Comp valve job
Pocket port
Surfaced
Cut for 1.625 springs
Cut guides for seals @ clearance
Install new springs, retainers, & keepers
1.88 intake valves keep the port velocity up in the larger runners, a simple formula for making 550HP+ with these heads.
Flow...
915J heads, fresh rebuild, flowed by BJR Racing;
Checked for cracks
Gasket Match
Comp valve job
Pocket port
Surfaced
Cut for 1.625 springs
Cut guides for seals @ clearance
Install new springs, retainers, & keepers
Flow chart attached
Also see...
Yes, 1.88/1.60. If you look at the flow sheet it says the valve size, the flow, and a simple formula for making 550HP+ with these heads. On Bobby's link above, he says he likes using 1.88's to keep the port velocity up;
"On the 340 engine you should use the 1.88 intake valve to keep the...
Checked for cracks
Gasket Match
Comp valve job
Pocket port
Surfaced
Cut for 1.625 springs
Cut guides for seals @ clearance
Install new springs, retainers, & keepers
Flow chart attached
Also see: http://www.bjrracing.com/small_block_heads.htm
$1299 + shipping from 97756
Thanks...
Another bill in at the Gov's desk, they want to tax health insurance preimums to pay for those who are uninsured, so now I have to change my new license plate frame to read; "Honk if I'm paying your mortgage AND health insurance!"
Hey! Check out this guy in Oregon, he selling all his cars;
http://www.slide.com/r/WZ7zMqsd6D_Cvv_yZs67S1Wa3eh_InpA
Craigslist PostingID: 784618485
Oregon>Bend
FYI
I have a friend with big block Dart that had overheating problems, his fix was a 8 blade hi-perf Carter pump which he overdrove then put the flex fan as close to the radiador as reasonable, never could get an electric fan that worked well. Now he says on a 110* day he can idle all day and...
You're right!
After doing a little math to fit a square peg in a round hole, RCI makes a 12 gal cell 17x17x11 that drops right in.
Now, because of the sump hanging down, do I need to make a support for the back half of the cell to prevent sagging?
If you can, That would be a big help please. Even if you know who makes the cell and how many gal it is, would get going in the right direction.
Thanks!