Recent content by RAVano

Looks to be 7290 on all ends. Must have been a conversion u-joint on the rear I put on.

Looks like it’s 3.25” in diameter and it’s 48” u-joint to u-joint. As far as modified from stock the only thing I did was put the 7260 u-joint on it about 5000 miles ago. Unknown if the front was ever change before my possession. No vibrations what so ever before it was pulled out.

Used driveshaft out of a 71 Dart with 727 8.75” combo using 7260 u-joints. Located in Connecticut. $200 plus shipping

Complete but used 727 kickdown with the bracket for Holley carb. $250 shipped from CT

Stock 1971 cluster. I just cut out the speedometer part and added a panel with New Vintage gauges

When I ran a PTC converter with my 5.9 magnum I ended up having the flexplate milled down where it was hitting that ring on the converter.

Gen 3 to 727/904 flexplate with ARP bolts. $100 plus shipping. Has less than 2000 miles on it. Located in Connecticut Part #7279048sf

Kilduff #1157 for 727. Has a carbon fiber overlay and dummy lever with 1 micro switch in it. Switch can be used to activate OD, Line Loc or anything 12 volts. Comes with shifter cable and bracket. $400 shipped. Located in CT

I was doing it for the esthetics. I have a little OCD at times. What I noticed is that the master bottoms out before the pedal hits the floor. I wonder if there is an internal stop in the master or do you have to adjust the pedal to hit the floor before the master bottoms out. I’ll reach out to SST

Tightened everything up a it’s not as bad as I thought it was going to be.

I just about run out of adjustment on the rod when I try to get the pedals to match up. It’s fine if I set the clutch pedal about 1/2” lower than the brake pedal. I’ll wait till I bleed it before I mess with it anymore (Don’t want to cycle it while it’s dry). Worse case if it bothers me I’ll...

Thank you. Just wanted to verify the pedal height.

Anybody who is using the SST Hydraulic clutch kit I’m curious as to the height of the clutch pedal in relation to the brake pedal. Please post pictures if you have any.

SOLD!

They do have the 73+ ball joints. I could get a quote for you tomorrow. Also I do want to let you know I have a guy from CT interested that reached out first. Just waiting for his response