Recent content by redcuda

2892 482 are the numbers I find

I have a 71 cuda (340) bellhousing, what should the tooth count, outside diameter, and the distance between the press. plate bolts be? I'm converting my 66 to a 4speed, is there anything besides the "conversion z-bar" that I'll need? I have a smallblock flywheel now that measures 13.5" outside...

what is a good-cheap piston for a 360. looking for .030-.040 and something closer to zero deck. I see some Speed Pro Hypereutectic's on ebay.... anybody know if there any good? How's the deck clearence? Thanks in advance!!

Its a 66 car with 68 engine, I do have an aluminum bell housing... probly off an e-body? they look very similar side by side. I'd like to use it because I have the flywheel and clutch setup that was with it. but I was worried about clearence and fitment in that older a-body. what do you think?

I have the bellhousing off of a 66. but when I put my 10.5 flywheel on the crank the starter will not fit. Is there a 9'' flywheel or something? are they hard to come by, and what engines used them? Its going on a '68 318 engine. Thanks in advance!