Recent content by rmoore0088

I think The Wall is gonna get this one. I have a very badly worn exhaust lobe on my camshaft. I ordered a new cam .454/.454 lift, all new lifters and double roller timing chain to get her all going again. Thanks for the help everyone!!!

I just swapped my slant six for a 318. It runs great at idle or at low rpms. You can rev it in neutral and it sounds fine, but when it is in gear, it backfires real bad right before it shifts. After it shifts it doesn't backfire again until you run the rpms up again. It's a 650 holley dpeardbore...

I just did this swap. The trans cooler lines won't work. I ordered mine pre-bent and ready to install from rightstuff detailing. They were stainless for $40. The starter and just about everything else will work off the front of the motor, I believe the water pumps are different, not sure...