Recent content by RPMmachine

also some pedal assemblies use plastic bushings and the HD units use bearings.

The jeeps have an overdrive transmission so most of the jeeps have 3.55 or numerically higher gear ratios. Really check your local salvage yard good for a rear end. I went to my local salvage yard and asked if they had an 8 1/4 out of an Abody and they said no we havent had one for years, as a...

That is my same reason for considering one also. Control freak IFS has a front suspension system for the a bodies also.

Do you still have the spare tire drop?

i used to paint with no mask, it caught up to me and i was coughing blood for a couple days, its already bad enough that i smoke! but your fast back is looking great

Im located in annapolis MD not too far away from NJ. Im interested in your disc brake parts k frame and lower control arms with sway bar, and the upper control arms. If i drive up there could you give me a deal on the parts? Any way please send pics to my email, toniosbourdas@yahoo.com what...

are those spindles based on a body height or are they the 3/8" taller f body units?

why would the steering column affect the centerlink/pitman arm/idler arm

For my 8 1/4 Im planinning on getting a 29 spline suregrip and 3.73 ring and pinion from a jeep cherokee along with the rear disc brakes and then get custom axles built in 29 spline and stock a body length, Im tryin to build a gorilla 8 1/4 lol. also planning on a rear end cover that supports...

does it make a difference if you remove the brake assembly off of a jeep with a dana 35 rear axle or does the jeep have to have an 8 1/4? there were two rear axles optional in the 1994 through 1998 jeep cherokees, dana 35 and 8 1/4

I installed an 8 1/4 in my 1967 barracuda fastback and im planning on doing this swap also. Do the emergency brake hardware from the jeep work with the 8 1/4 a body rear? Did you have to weld a mount on the housing for the caliper hoses? Thanks man!

Hello, I'm Tony, I'll be turning 18 in december(next month!). Right now Im working on a 1967 Barracuda Fastback that i bought about 3 or four months ago with all the money i earned delivering pizza with my little VW that i bought in January 2009 with saved up money. My Dad got me into mopars...

what about 1 7/8 hedman huslers with 3.5" collector that runs into a 2.5" full exhaust in an abody with a 360

does anybody have pics of the hedman 1 7/8 installed?

does this coil over kit improve handeling? is it better than thicker torsion bars