Recent content by salami340

I had my multimeter lead alligator clip to the small terminal brown wire on the starter (solenoid) and the other lead on the battery positive and this showed 12.5 then dropped to 1.5v when cranking. When connected to the battery negative or the engine block drops to 10.8 while cranking. I went...

So yesterday I tried a couple things. Replaced the starter relay with a new one which had no affect. I also tried bypassing the ignition ballast also with no affect. I will keep going tonight if it cools down a bit so if anyway has any suggestions I can try that would be great. One thing I...

I tried this and unless I was doing something wrong I was not getting any ohm reading on my meter.

See my responses in red above. Thanks for your feedback!

I'm 99.9 % sure it is not related to the amp. I'm assuming I was having these issues before I even took the dash apart. The amp allowed me to notice the problem. The amp is now completely out of the circuit and the voltage drop at the battery is still happening.

It still does it with the amp disconnected fuse out etc.

Hopefully someone can help me out. I've had my 71 Demon for about 3 years now and I'm trying to wrap up my new instrument cluster swap. I also installed a Bluetooth amp which sounded great until I started the car and it began to cut in and out. After futzing around with the wiring I checked the...

Area code is 60042 if you can ship?

Northern Illinois

I'm looking for an original working switch for the parking brake warning light that works or if there is an aftermarket switch that will work but I could not find anything in my Googling. The only switches I could find on eBay are attached to the entire assembly and I only need a switch. I...

Actually one of the first things I did was new Remflex gaskets on the headers and collectors which eliminated a leak I had on the passenger side header. I highly recommend those gaskets BTW

Oh trust me I do

Hah, well I hope would have noticed something that obvious...

Thanks, I will get it up on jack stands in the next couple of days to check the mounts and for any interference I can find and report back. It seems like mostly everyone is thinking it is an interference issue under load which I am hoping it is. I was worried it was an internal engine issue...

Haha, no problem. I very much appreciated all the responses I have been getting here. I definitely have some new things to look into. Unfortunately some stuff came up this weekend so I didn't get a chance to look into anything yet but the weather looks good this week so I should have plenty...