Recent content by saskatchewan

One upon a time I did a mild slant six build using a Holley 390, Offenhauser Intake with Dutra Duals and I was really happy with the results. I am contemplating another build but the world has changed over the last 20 years and the carburetor manufacturers are pushing customers toward throttle...

The offerings from AusieSpeed do look like the best available options for intake manifolds. And I have used Dutra Duals in the past and was happy with them.

Has anyone else seen this? Does it actually work?

Over the last 20 years, Clifford Performance has acquired a bad reputation for things like warped castings etc. Can anyone give me feedback on this? I am wondering if it would be better to deal with either AusieSpeed or Offenhauser in terms of intake manifold, exhaust, valve cover, etc? Thanks

Powertrain?

What kind of transmission?

Nice truck. Are the paint issues on the front related to rust? Have the floor boards been replaced? Do you have issues with vapor lock, or the carburetor/fuel getting too warm?

What do you think is leaking? The rear main seal? It is a crappy job, but I once changed one in a driveway. What are the needed repairs that you mention in your opening?

Does anyone know who would sell Offenhauser manifolds for the 1965 273 engine? The very old Offenhauser catalogue lists the dual port, but I am more interested in the 360 equa-flow manifolds, either the high rise, 5699 or the low rise, 5489. Does Offenhauser even cast them anymore?

Thanks everybody!

I am looking for an Ignition Control Module for a 1975 Dodge three ton truck. It originally had a 318, but, I think that it was swapped to a 360 from a 1973 Polara. Is it the same control module for either engine? Any suggestions as to what I should use as a replacement? I looked to NAPA and...

Hey Notadork, did you sell your wagon? I like the car and am looking for an excuse to travel to Fossil. I was there in the summer. It's too bad you did not have the vehicle posted then

Does anyone have any suggestions on how to set up east - west carburetor mounting on a 19 63 Valiant slant six? Any thoughts on these products is appreciated as I am wondering if they would still require a lot of fabrication. 1963 Plymouth Fury Parts | MN2236 | Torqueflite Kickdown | Classic...

If you can post more photos, that would be great.

The car looks great, do you have any more photos? Does it have the original brakes and ignition, or, have these been modernized?