Recent content by ScampChamp

hi everyone I fired up my sniper efi yesterday and it’s running great. I’ll add a pic of how I wired up the 12v switched ign as well as a diff one to a toggle switch . Where it says “IGN” means to the Ign1/ign2 wires that were spliced together. And where it says “fuse” means to an always hot...

I have a red, orange, and black coming from my distributor. The black goes to ground. And the red goes to coil + and the orange goes to coil - There is also a brown wire on the coil +. I am told in the efi kit. I cannot hook any wires to my coil except for the 2 wire that tell me too

Great thanks it is a #1 1975 Plymouth Scamp. #2 Holley hyperspark dizzy,coil, and box (no ballast resistor. #3 harness is stock. #4 will be running a high flow fuel pump and possibly electric fans one day. Thanks I have a manual with the diagrams I just wasn’t sure...

Thanks everybody for the responses and thank you 67dart. So I understand what you are saying about having to use both connected together. Sorry to sound really stupid but how do I go about “connecting them together? “ add 2 extra wires coming off the switch and into my wire from the efi kit? Or...

yes stock wiring harness. And ballast resistor is already gone. (Currently running a MSD RTR dizzy

Hi guys I am installing a Holley sniper efi with Holley hyperspark ignition system on my 1975 Plymouth scamp with a 360. Holley says I need to hook up a certain wire to a switched 12v source (hot with key in ON position, and hot while cranking) and I cannot use the positive of the ignition...

1966 Dodge Monaco 2 Door, 383 big block 10:1 compression 325 horsepower 4barrel, 727 Torqueflite auto, power brakes, 8-3/4 rear end, A/C car for sale. 130,000 original miles. Car is all original. Clear Missouri title. Starts runs and drives great!! AM radio still works. Bench seat has a few...

For sale used 308 cast swirl port heads off a 1989 1-ton B350 ram van. Roughly 130,000 miles on them no cracks just one burnt exhaust valve. Smog ports plugged. Was using on my scamp 360 setup. Not sure of what reasonable asking price or what shipping would cost? I will post more pictures...

@dusterkid71 wondering about some suspension kits my self. Mostly front rebuild kits as well as adding a sway bar to the front end to help correct bad over steer and lean etc I upgraded to super stock springs in back and with the worn out front end it don't handle to well.... At all. Good...

BoingK. Thanks for a cam suggestion and dual plane is what I'm going with I will check at that cam and do some research.

Yes I am talking Indy aero head 587 heads and ok I will do that thanks!

Any how. I plan on sticking with switching to my dual plane intake but am wondering mostly on which heads to use or install and cam suggestions of any per setup thanks

Right now it has a torker 340 single plane on it. Thanks from what I been reading a dual plane will give me better low end and starting/ drive ability then a single plane which is more top end?

Right now my 1989 roller 360 is running stock heads( motor pulled from 1 ton ram van) which I believe are the 308 swirl port heads. Currently the motor has a eddy 650, single plane intake, hooker long tubes etc. I have a set of 587 Indy heads with the larger 2.02 valves, I am considering...

Awesome that all sounds great too me. Any suggestions on where to find or buy a carrier. AND or some gears for it. Thanks again guys