Recent content by seitz

well after a new fuel pump installed I still had no fuel put the car on my Hoist and was going to pull the sending unit and notice the short rubber line that goes from tank to the steel gas line had a kink in it restricting the fuel. I guess it must have had a small kink and with bumps and what...

so i took carb apart cleaned it up one needle was not opening so fixed car does run better but still having the stalling issue i am going try replace yo rubber lines once again another fuel pump i guess not sure what else to do everything on this car is brand new

i have taken crab apart and cleaned everything up on seat was sticking and fuel was not coming out properly and the carb was gummed up a bit so i have cleaned it all up put it back on car fired up much better than i was when cold have not hacked a chance to go for drive but going to take it out...

i have played with idle mixture i dont seem to help but i will take it out today and when it tries to stall out all give the screw a turn and see if it make a difference thanks

Thank you i will try that i does start up after stalling but it has to crank a bit brfore it goes so it could be flooding rather than starving...

yes i actually did drive with cap off last week and it was still the same and no Vac leaks detected

mechanical and yes it’s 2nd new one i thought first one was bad so installed another new one but its same never somthing so simple lol

going to check that in morning hope thats the issie

its a new sending unit thks

i will put some air to it and try that im open to any ideas lol thanks

Have 1970 340 Duster Auto running a Carter carb mild cam 10:! Comp car runs great for about 4 miles then will stall out if i put in neutral it will not stall if i pump gas pedal in drive it will stay running i know its a fuel issue just cant pin point, new fuel filter fuel lines are all new...

i have a seat from a 1972 duster that was in a car i owned and it is different than my 1970 duster top as well as bottom brakets e different seems strange

so i got the gauges to move but now the go to far right. i have 11 volts at the secondary terminal at each gauge but it flashes so this i assume is what the VR does so the voltage fluctuates down to 5 volts. this also tells me VR is working i actually install an external VR and it does the same...