Recent content by SheSaid

Bump $200

Bump. Price reduced to $650

Bump. Price reduced to $250

I have a complete set of roller lifters for la small block. These are new and only used to mock up. I think they are the early Comp lifters, but I do not see a part #. These fit in the bores of my block fine, but I had interference with the push rods on Trick Flow heads. Might work fine in...

I have a Scarebird kit, with original spindles and hubs for a 1969 Dodge Dart with 9" drum brakes and small bolt pattern. I mocked up this kit and found that I had a factory sway bar and it would not work. Went a different direction. So this will not work if you have a factor sway bar. This...

I have an orginal 1969 Dodge Dart 340 radiator, shroud, and fan. Worked when last run in the car 10+ years ago. Has not been restored. I am not aware of any work to the radiator. $400 for all three plus shipping.

It has been a long time since I have been on FABO... Update: the car has been done for two years, cruises during the summer and winning car shows. Mom loves it. Still needs some fine tuning and adjustments. This website helped so much through the process. Hope to get started on my dads old 69...

Hello FABO, Got my X heads back from the valve job. The shop was really impressed with the small stem of the Hemi valves. With proper porting and bowl blending they said the heads should make good power. They had to cut the 2.08 intake down to 2.06 to get it out of the hardened exhaust seats...

Hello I have a total of 7 Chrysler steel wheels plus some old 14" tires that are dry rotted. The wheels are small bolt pattern 5x4. Central Ohio Local Pickup Only. I will be at the Swap Meet at the Ohio Expo Center this Saturday. $100 for all

Hey thank man. I am listening. The 1.80" installed height comes from stock specs for these springs as installed on a 6.1l hemi. I wanted to install them as close to stock height as I could so I could have the option to run as big of cam as possible. I see what your saying on geometry. I also...

Well, I mocked up the valves in the head next to the old valves and measured my current spring install height. With the valves sitting in the old valve seats I have 1.62" spring install height on the intake and 1.58" spring install height on the exhaust. I am aiming for 1.80" install height. So...

Thank you for the info I will go to the site and do some reading!

Just an update... almost 5 years later... I still have the 6.1L Hemi valves and X heads sitting in the trunk of my Dart in a barn this whole time. Hope to get back on this project this year and I'm starting with the heads. I am taking the heads and valves to machine shop in Groveport to...

Hello I am in search of a rear trunk lid panel for a 1969 Dodge Dart GT convertible as seen in attached generic internet picture. We have one now with a large pole dent so looking for one that is straight and clean only needing paint. Thank you

Hello Fabo The Dart is getting shiney peices put back on at the body shop. Very exciting!