Recent content by Skeven33

I have a 68 340 Block. I believe it is punched .40. Make me an offer. Located in Colorado.

I bought the same exact Balancer from KMJ and it didnt fit at all like it should> also pushed out all my pulleys about half inch cause that sucker is so wide. ended up just buying a stock balancer from nappa since my car is mainy street use with limited track use. would not recommend anyone buy...

Blue Barracuda in Gone fishing with joe pesci. Plenty of shots of it.

How do these cruise nights work? Being only 17 i look for any way to get my mopar out on the streets. I wish it was like the stories that my dad tells me of cruising main street every weekend. Supposedly Longmont was pretty big for cruising, as they now have big NO CRUISING signs posted on Main.

its a mechanical water pump. 180 stat. 750 holley carb. I live real close to denver so elevation is 5280 and ill be running it at bandimere speedway which is known for altitude

very true it is quite loud with the headers and exhaust. Im going to fill the rest of my tank with super and see if it helps. is there anyway i can tell whether i have detonation or not?

thanks i think thats the route im going to go and install a clutch fan. i just put on a shroud with a flex fan i had. hoping that will get me by until i buy my jegs radiator.

Destroy my engine? it runs just fine. no pinging. but it could be bad for the engine with no noticable effects while running low octane?

could not running a high enough octane be contributing to my heating problem?

havent hammered on it yet. trying to put some miles on the motor before i do hammer on it. just drove it around the block a couple times and it heated. i dont think we are running lean. being only 17 i havent been around these cars as much so im not positive. how could i tell? also with that...

Im thinking the mopar ford style is for big block chryslers. cause i definately need the chevy style for my duster

moparmade43, hopefully both of us can get our cars cool enough so that we can actually enjoy them. Gotta love this high performance stuff. just wondering with your edelbrock heads did you run into anyproblems getting anything else to fit such as headers? or getting valve covers to seal? My...

not sure the cfm on my electric fan, it is quite big and moves quite a bit of air. just installed a flex fan and shroud to go with the electric fan hopefully it will cool a little better. im looking into an aluminum radiator if this doesnt work.any recommendations on good aluminum radiator...

What kind of fuel should i be running with that kind of compression? i also have the six pack fiberglass hood. what kind of radiator were you running to keep your 340 cool?

head gasket lined up blocking no water jackets