Recent content by smlveightis

And a few acoustics....

I've got a few guitars. These are my electrics. Early seventies' Crestwood LP copy, '88 LP Custom Showcase Edition, '90 LP Standard, '90 LP Studio.

Until we meet up again, so long my friend! Rest In Peace

The drills Toolmanmike speaks of can be re-sharpened (all drills can be re-sharpened), but I doubt you will find anywhere to re-sharpen them at a reasonable cost (vs buying a new drill). Unless you have a machine to drill on (lathe, mill or drill press), I wouldn't bother with the M42 cobalt...

How much for trans/flex plate, and where are you located in Michigan?

If your a fan of Disturbed's "Down with the sickness", you might enjoy this. My good friend's son and Suzy Cole (DJ at WRIF in Detroit), put this together a few years ago.

Looking at engine from front of car, it is located between master cylinder and washer bottle

Dealer installed A/C on my 67 Barracuda. You can see where they cut the console to match the Chrysler "Knee Knocker" unit

Check "pure-gas.org", for ethanol free fuel in your area. You may pay a little more for it, than say 10% ethanol gasoline, but may well be worth it! Here in Michigan, there are countless "pure gas" stations, due to the amount of water we have here (think Marine gas).

Agreed!

Debated powder coating mine body color. Cheaper to buy some rattle cans of paint for the hood....

Welcome aboard from Westland.......

Sorry, a bit far for me (3 hours)

Call them up and ask for Dean, he is the Mopar brake guru there.

As one of the local Detroit newspaper columnist pointed out in an article, "there is no Mr. Baseball, no Mr. Football, and no Mr. Basketball, just Mr. Hockey"