I believe this fits stage IV heads #8 intake port is misaligned lol somebody at the foundry wasn’t paying attention! Don’t know what it’s worth. The part#is in one of the pics. 300.00 OBO
I have this unfinished intake I would like to sell, I guess you can make it fit 59* or 48* or a small block Chevy for that matter lol obviously the intake bolts have to be machined. And intake ports are like 273-318 size. I’m asking 250.00 shipped.
I will tell you what it’s for. I have a small block that makes around 900, it used to be in my 3100 lb duster with a stick. I bought a tube chassis 71 gremlin that was set up for AMC engine and PG. the car all said and done will probably weigh around 2500. I want to use it in no prep small tire...
I got the build sheet I found my files so it looks like a really good trans I was looking for a 1.80 strait cut gears but let me think about it and talk to my tranny guy see if it’s good for what I wa t to do
Came off a good running 340. Has 2.02 / 1.60 valves in it already, clean no cracks springs are for a hydrolic flat tappet ( had the 509/292 cam in it. 300.00 I’d rather not ship these
I’m sure they’ll be and improvement not to mention there a little lighter and engine temps should be lower. Mine are stepped way more room in the engine compartment and changing plugs are a breeze! They also have the bungs installed for 02 sensors
Hey rob what’s up. So the headers I traded the intake for are the hooker 5303 1 7/8 slip tubes for A and E body small blocks. The #7 tube hit the steering column and the frame by the proportion valve so that’s why it’s flattened like that. Every tube leaked where it entered the collector on the...