Recent content by spd691

How is the roof panel its self removed from the sunroof assy?

I see the ramps on the slides that it climbs when almost closed. Right side looks turned a bit. Ill look closer after work.

Hey guys, I'm officially out of my comfort zone. It is in (or was) my 73 Dart Sport 340 4 spd. I know sunroof parts are hard to find (impossible). Fortunately mine works pretty good, except it doesnt like to rise when fully closing, I have to help it. I had a rattle that I couldn't take anymore...

That is correct. 1973, no safety bumpers, but had the buggy bumpers. 1974 + had both I believe.

Thank you for the response, but looking for something in better shape. Something Ill probably never find...

The one on my car (above) has the bumper jack holes towards the outside of the bumper. I believe it to be 74 and up. The ones with this posting is a 73 (I think). The bumper jack hole is a little closed to the center of the car. Also a 73 does not have as many holes. No lower holes on the out...

I am looking for a rear bumper for a 73 Dart Sport. I have a VERY nice 74 up rear bumper to trade if interested. Located in NH.

Thanks everyone for the help. I have a set of gears now!

Yes but they don't offer it.

The highest they go on a 489 case 10 spline is 355.

I have a 489 case 8 3/4 rear. Has 391 gears in it now with a Powertrax Grip Traction system carrier in it. 10 spline. Looking for a set of 323, 10 spline gears. I could use 29 spline, but that would mean buying a yoke also. Need to curb the spending a bit. Any help would be appreciated. If I...

I have a 73 Dodge Dart Sport 340. I'm trying to rebuild the front suspension. I have the left side complete. I think I have the wrong shaft for this car. Let me start by saying the front end of this thing, along with other systems have been hacked. My problem is the left side shaft looks like...

Don't hate me. I didn't know at the time. Speedmaster closed chambers. gasket lines up nice with heads.

I just received my new Edlebrock LA Air gap. Lots left on the table with the ports. Using Mahle intake gaskets as templet.

I took out the spring and check valve found a spacer that fit right in perfectly. Working it now.