Recent content by Stauch

Nevermind it was the column sleeve. I made it more circular and it went right together....Should have looked closer in the first place.

I am replacing the steering column collar as well. Eliminating the shift on column. I cannot get the collar to seat correctly or both bolt heads to catch and tighten..... Been playing with this for hours and it's not cooperating. May be an issue with the column too. The sleeve that the bolt...

Thank you guys for all the help. I'll give it a shot.

69 Dart Swinger

I would like to get my map light working. Originally wires were cut a few inches from the lamp plug and switch plug was totally gone. Is there a simple drawing anywhere of how it should be wired?

Thanks Redfish!

Makes sense. The car used to have a roll bar. I bet the armrests were moved because of that. Thanks for all your help!!

I agree. Probably the only easy answer short of relocating armrests

Thanks. One theory I had. Are the armrests with ashtrays for four door models? I don't think there is enough difference in length though.

Well the screws seem to going through correct holes behind the panel. I don't know

Why yes I do. Window crank is the same length as the front ones.

This is the drivers rear but both sides have the same issue.

Thanks Cudamike

Steven, Thank you very much that's a big help!

Thanks I will look into that. Much appreciated!