Recent content by TheChosenMosin

Sorry it took a bit to reply but I finally got it running. I rechecked everything all over again, I poured transmission fluid down the intake to help seal the cylinder wall, and then when in crank it started to fire. Only issue is when you release the ignition switch to RUN, all spark went...

I appreciate the thought. Here is where I'm at. -Cleaned out the line for the pump/filter. -Attached a bottle with some clean, fresh fuel. -Found out the carb had a nozzle clog (due to my cheap filter) so I just cleared that with compressed air. -With fuel entering the intake, still nothing. I...

I'm currently in the western part, Kitsap county area. Couldn't get to testing the a hose directly to the can yet, I should be able end of this week at the latest.

I haven't tried to directly suck from a can, I can give it a shot here tonight. I was hoping the flush I had from the tank was enough to clear debris and send fresh gas straight to the carb.

I just flushed all of this out of the gas tank too, might just need to replace it at this point since I'm sure there is more rust/debris in it.

Here is my 1971 Dodge Dart that, long story short, a family friend decided to be the owner of a chop shop and my almost completed project (literally a paint job away) turned my beautiful car into junk yard status. Because of the chop shop, a lot had to be done; brake lines were cut, the old...

Good evening all. I'm joining because A: I've gotten some useful information from here in the past and B: A good way to document my progress and gain some oh so needed help. I have a 1971 dodge dart that, long story short, a family friend decided to be the owner of a chop shop and my almost...