Sorry about that, didn’t realize it was full.
its fixed now.
I’ll measure the spacing between the outer holes this morning.
How much would one be?
I’m in Bradento, 34208. Thanks!
Anyone buying dash pad cores?
I just got a new one from Dante, he didn't need a core.
Just want to reach out before I trash the old one.
It's from a 1974 Duster.
Center of crankshaft to top of K frame needs to be 5 1/4"
Center of crankshaft to framerails needs to be offset towards passenger side 2 1/2"
Then make sure your valve covers are plumb to framerails.
That's your factory starting point.
Engine location is critical in these swaps.
1/2" too low or offset will cause problems.
I just did one with a motor plate and the directions had the dimensions.
I'll see if I still have that tomorrow......
That actually slipped off my radar but yes, I do want them.
Moderators removed your address and name, could you pm me that?
I'll get you a check rolling.......
Thanks.
david
Well, I'm nowhere near ready for that (not even running yet) but I'm sure you don't want to hang on to them.
Can you get the price for shipping to 34243?
And would you happen to have the glass channels for a Duster driver door?
I’m marking this sold just to get it off the list.
I pulled the intake and valve covers and discovered a set of 68-70 340 heads. Gonna rethink this situation.