Recent content by tomg45

coolant sensor and map sensor have been changed and the distributor and it still won't start.There cant be much left to change.

I can't get the damn thing to start at all now.It's driving me nuts. I will try the coolant sensor. Is there a way to hook up an hand held analyzer and maybe get the fault codes that way.

It looks like it was never equipped with a 02 sensor.The fuel filter and fuel pump is new as well.So is the map sensor. I did clear the fault codes a few times and it didn't do any good.I also changed the throttle body and it still did the same thing so I put the original one back on it.It...

This is a 1973 Duster for sale near Windsor,Ontario. It is in mint condition,and has had a lot of new parts put into it. It is owned by a buddy of mine. He also has a 1970 Duster Roller for sale for $3500.00 It is also very solid.If you need pics let me know. Later Tom...

I have a 1988 Dodge Pickup with a 318 throttle body. When the truck starts when it is cold it runs great. As it warms up it starts bogging and blowing black smoke like it is getting too much fuel. Then as it gets warmer it acts like it is not getting enough fuel and it stalls. If I dump fuel in...

This is a buddys 1970 Duster Roller it is a very solid car.It is located just outside Windsor,Ontario. http://windsor.kijiji.ca/c-cars-vehicles-classic-cars-1970-Plymouth-Duster-Gold-Duster-Coupe-2-door-W0QQAdIdZ197700605

There is a yellow wire and a black wire hanging under the steering column that I don't know what there for.maybe that is my issue.Any ideas how I can figure out where they go.The number on the yellow wire is 3747114. does anyone have the wiring diagram that I can download? Thanks Tom

I am trying to figure out why I can't seem to get the running lights in the front and also the front turn signal lights to work. When I put on the four ways they will flash. The bulbs are all good and the fuses are OK. I don't have any fender turn signal lights hooked up yet either.I don't know...

I pulled the other tire off and the drum went right on and fit good,but the shoes are worn out. The adjuster is all the way in,and the drum will not fit over the shoes. It seems the new shoes have to much meat on them. I was thinking about getting some 9'' shoes and see if that will work.The...

I have a 74 Dart Swinger with a rear end out of a 74 Dart Sport.I'm having a heck of a time trying to figure out which drums to use.I bought a new set of 10'' drums and they don't seem to fit. I measured the shoes and they seem to measure up at 10 and a half. Did they put 11'' drums on that...

Thanks for the pics. It flew together pretty easy.

I have a 74 Swinger that had the trunk lid springs and hinges removed before I bought it. Does anyone have some pics or installation instructions.It's driving me crazy. Thanks Tom