Unfortunately I'm not going to Carlilse; but depending on your route I could be on the way? I'm real close to I-70 & I-77 interchange in Ohio - looks like you're in VA so might not work for you... but putting it out there.
That was the only picture I had on my phone - it's drum to drum - backing plates and such were off when painted.
I'm switching to a narrow rear so this has to go.
8 3/4 rear end originally from a 69' Dart I believe; freshly painted, ~ 10k - 12k miles on it since it's been rebuilt. Complete drum to drum. Has a 489 center section, with a clutch disc style sure grip, 3.91 gears - built by "Dr. Diff". SBP axles; has had perches moved inline with frame...
Need to clean out my garage and get rid of some stuff:
70 Dart steel factory hood - NO trim piece, was cut for 340 scoop holes - no dents/dings; is B5 blue. Underside had some scale - painted 15+ years ago and still holding up good - just a little rough. $250?
70 Dart trunk lid - good shape...
Have a set of (4) stock Ralleyes w/ 215/70-14 tires. 50%+ tread on them. Have recently be repainted, driver quality trim rings/centers. Have 10 RH and 10 LH lug nuts to go with them. Screw in valve stems. Located in Ohio - willing to meet within a 3 hr drive of Columbus; prefer not to ship...
Have a square back alternator that has been rebuilt w/ a high amp kit (can't recall the amperage - want to say 120 maybe?). Is used but in good shape - will throw in a new voltage regulartor too. NO PULLEY. Asking $90 plus shipping.
PM me.
Have a 10.5" clutch setup for a LA engine. Factory steel flywheel (might need resurfaced) w/ Hays street/strip pressure plate. I have a Hays disc for a Tremec TKO - I'll include if you want or you'll need to get a disc to match whatever trans you're using. Is used but has lots of life left...
Have a genuine Mopar mini starter for sale. Had this rebuilt last year ($60) and switched to a RobbMC starter - just don't need it - asking $60+ shipping.
PM me.
Thanks.
Have a LA engine 10.5" Hays Borg & Beck style clutch with an aluminum flywheel & ARP pressure plate bolts. Used but in good shape, has been balanced with the flywheel. Flywheel is a custom segmented insert design - Google "cyn-r-g" flywheel for details. Is a piece you don't find made for...