Recent content by Trey Osborne

Thank you all for the help I appreciate it. Its all fixed now, I just installed a reman alternator instead of waiting for parts to fix old one, still will keep it in case if this reman ends up being junk. I've put a few hundred miles on it now with no issues.

I think I figured it out, I put bushes in alternator around 4 months ago, the little isolator that keeps the brush from grounding to the body of alternator is gone. I believe I probably overtightened it and broke the isolator as it is no longer there. I will reply again when I get a new one and...

Yes I mean max charging side. Battery has been ran super low before, and boiled. (I had this issue and had to get home, went from disconnecting alternator to reconnecting to get home). I just bought another regulator, no change. I do have a multimeter and battery voltage reads 18 when I rev it...

My car is a 1963 Plymouth valiant with a 1978 aspen engine, harness, alternator, and voltage regulator. The amp gauge works fine, but at anything over 2k rpm it goes all the way to the max, so I replaced the voltage regulator. That didn't change anything. I tried running a wire straight from the...

$150

Here for sale is a 1979 lockup 904 flex plate lockup converter and bolts for a slant 6. From my 1963 valiant, got pulled as I converted to manual. Works perfect. I also have a slap shifter And cable that can go with it for extra. I can drive to deliver just pay gas. Located Columbus Ohio. $200

what rear end? suregrip?

It was the spring. Thank you for your help I really appreciate it!

Thank you for all the information! I will check it out! No I was just using it that way to show what it was doing. I wasn’t actually on the bench shifting. Actually had it in the car then realized it was messed up.

I just bought this a230, whenever I go into reverse this block comes up and holds it into gear, until I push it down and then I can change into 1st. But once I go back into reverse it comes up. There are a few of the blocks around the gear but only this one does it. How do I fix this/ what does...

Last one did not work out. Still looking

Hello, I am in need of a 903 transmission for my 1963 plymouth valiant. any condition as long as the gears are all good. Would like to be within driving distance of Columbus Ohio.

Pulled all of this out of my valiant to convert to manual. Everything works as should, including the lockup converter. What you see is what you're getting minus driveshaft, I'll post pics of it later I forgot. Trans, converter, kickdown linkage are from a 1979 aspen super 6. Grandad put the...

I'll get the good gasket you recommended. I'm 17 so to spend $50 on the choke upgrade doesn't make sense for me money wise. The factory setup is working just fine for me as of now.

thanks again! I’ve got a exhaust leak at the head so while I have everything off to fix that I’ll go through the carb since I’ll have it off painting the manifold.