Recent content by tubbedamx

Look into what it takes to join summit racing pro shop. I was able to with a NHRA membership and number. It’s usually 15-30% discount.

I can’t answer all of your questions but here’s my opinion. I have a 90 roller cam block as well. Do you need hardened pushrods without guide plates? To number 1. Trick Flow® Rocker Arm Shaft Studs CHRYSLER 5.9L/360 Mopar small block LA - In Stock Filter Options - Free Shipping on Orders...

These have a good reputation Sick GPS and Security

I just got off the phone with Harland Sharp. Oddly enough, they get alot of phone calls about this every day. Since I have pushrod oiling already, there recommendation was insert a piece of dowl rod into the cylinder head oil feed hole, roughly 30 thousands smaller than the diameter of the...

It’s a speedmaster casting that Brian at IMM ported and assembled. The engine is doing both, pushrod oiling and oiling to the shafts. I wonder if the oil inlets to the shafts could have have restrictors added or new shafts be machined with smaller holes than the .125 they come with. I...

thanks for the replies… Who’s adjustable roller tipped bushed rocker assembly is everyone using? Could the Harland Sharp rockers be machined be accept a bushing? Remove the bearing package all together. What machine work could be done to the Harland sharp shaft to reduce oil...

After a little search, it seems the holes in the Harland-Sharp shafts measure at .125. Why couldn’t those holes be reduced in size? Either bushing them down or buy new shafts from Harland sharp?

Probably, but I didn’t let it run that long.

Hi Good morning. I recently made some changes to my engine combination and as a result have lost some oil pressure. I switched from Crane adjustable bushed adjustable rockers with banana grooved shafts to a Harland-Sharp kit. Harland Sharp shafts and needle bearing rockers. As a result, I lost...

I’ve been getting asked if the black powder coat will come off. Yes, it will come off with a light media blast. Thanks

Just an idea and Im sure you thought of this already but you can have the pdf printed onto vintage appearing paper.

I’ve never seen link bars on the inside, what’s the advantage? I don’t understand the terminology on comps site. The bars are going to to face the block and not the lifter valley. Here’s a picture

Working with Mike was great, he’s knowledgeable. I did have to wait for a core to become available. I ending up with a solid roller and his solid roller lifters, they cleared the block just fine. I'm not a huge fan of Comp, just mass produced. I would at least call and talk with them before...

Go Seahawks!! And good commercials.

1967 Barracuda Rocker Molding Trim One year only. I assume they will fit 68-69 Barracudas with right clips. Driver quality, in good shape considering there 58 years old. $475 plus shipping PayPal or money order Will be packaged and shipped in pvc pipe, insured for total amount and shipped with...