Recent content by wardy

Vallo!.. thanks mate. im hanging to just drive the thing. 10's with the 318 is the goal before the program is stepped up. This thing is a streeter so dont wanna go too overboard lol Thanks!.. im not overly familiar with the ms3x. From what i have read it is very similar with only a few less...

Digging up an old thread, I hope you guys don't mind! Im from Australia, where the 360 and especially the 340 are very rare.. at least for a good virgin bore block.. people are asking $800-1000+ just for the block and caps The 318LA can be picked up for a couple hundred dollars (AUD) My...

Or do you mean the cork Valley gaskets for front and rear? Is so, throw them in the bin, clean the manifold and block with solvent. And put a nice fat bead of rtv instead of the gasket. Sit the manifold down and tighten. Leave overnight before starting. Best thing you will ever do lol

Hi guys, I'm chasing a good used condition. Msd crank trigger wheel and sensor bracket to suit LA small block. I don't need the sensor as I'm switching to a holley hall effect. Hence chasing a used one. If you have one lying around and want some cash please let me know before I buy new...

Hi guys, havnt been on here for ages! My current project is 95% complete hoping to hit the key around Christmas. It's a 1969 VF valiant regal station wagon. Factory v8, so it's actually quite rare. 320" small block, standard bottom end for now, 1008 gaskets, studs. Ported j's with...

They are made by champion wheel company

Haha Yeh it'll make alot more sense once your actually looking at it. I was confused when I first started too.. Just leave the top fitting open if you don't plan to use it.. Did you get any lighter springs with the wastegate? I always like to start low (in boost and timing) and slowly creep up...

Sounds awesome mate, keen to hear the results! Wastegates work best when you have the closest Possible springs to your desired boost level fitted. But remember you can't run less boost then what springs are in there. Your boost reference gets fitted to the barb on the side, so when the boost...

Great work on the headers mate!.. they turned out great. What issues are you having with the msd, bov and wastegate? Id just trigger the launch control with a separate switch mounted somewhere running through a relay, only problem I can see running it along side the roll control is the...

Good to see a few Aussie members getting amongst it! Bit of a change from last post for me, now running a 347ci new gen hemi, billet 80mm precision turbo and powerglide.. Will have my own workshop setup serving the Gold Coast and Northern nsw areas soon.. If any fellow mopar guys and girls...

Some new ones from me Front- 15x3.5, 1.75" bs.. 26x7.5 Mickey thompsons Rear- 15x10, 3.25" bs.. 275/60 et streets

Hey Zeus, thanks a lot mate. Seems there are a few H6P members on here ;)

Thanks guys.. Yep front seats have red covers to go on.

It will still be street driven, but not much. I have another bare trunk lid that will get bolted on, full exhaust. And the rollcage can be completely removed Will probably get another set of wheels too

Few new pics, Radiator mounted, radiator support brace made. Hot side piping all done, and seat brackets made up. Nice productive weekend