Recent content by wcelliot

Seems the front gasket is finally available. Yea!! Anyone have a line on a rear window/windshield gasket?

Like these? Dodge Chrysler Plymouth moulding clips-1/2" wide Thanks!

Finally getting my grandmother's (bought new) '67 GT back together... I had to replace one of the door windows and the glass came "bare" without the plastic sheath that is present on the leading edge other window (I would assume to allow the glass to slide easier against the felt) and the guide...

Wanted: right rear (passenger side) window regulator 1967 Dart 2 dr hardtop Need ASAP as we are in final assembly and realized we had two lefts! ;-( Thanks! Bill Frederick, MD

thanks!!! Bill

Are the body peak moldings (the trim that runs from the front signal light repeaters along the top of the front fender, back across the top of the door and on back to the rear fender) available in reproductions? The finish on mine is horrible, but they are fairly straight. I'm considering...

For both windishield and rear window. Just checking in with the experts to see if there has been any update on anyone getting this reproduced. I thought Layson's was reproducing at least the front, but they just told me to "check back in 2010!". Would prefer a new reproduction, but will...

I know it's a long shot, but looking for NOS, NORS, or very good condition used front windshield gasket and rear window gaskets for a '67 Dart The rear gasket was beyond redemption when we pulled the glass... the front will not likely survive another installation.... really don't want to...

I'm restoring a very early (Sep 66 build) '67 Dart GT. I replaced one of the doors with a good used door (from a '68 we thought) and it fit nicely. But as we were working on the interior, we noted some significant differences... in the pressing of the interior panel itself, but more motably in...

Thanks; I had not seen that but it confirms 71483 as the right color. Thanks! Bill

That's what I needed; thanks much!! Bill

Hi guys. I'm doing a ground up resto of an early production (Sep '66) '67 Dart GT Paint code is PP1 http://fnader.com/DartGT (Sorry for the picture quality, but you can see this is a moderately dark red, no orange tint at all) My Chrysler hertiage certificate calls this "bright...

I'm doing a fairly indepth resto of a '67 Dart GT. My emblems ("273 4 barrel", "Dart GT", etc) are faded... are there reproductions out there that are of a good enough quality to use or do I need to seek out NOS? I know some reproductions in other marques leave a lot to be desired...

Thanks!! Bill

Looking for a quality cap with brass contacts for my '67 273-4 with the factory dual point distributor. Tan would be a plus. So far, the only caps I've been able to find have the cheaper contacts. I saw a note that an Accel 8830 (cap and rotor) would fit but Summit only shows those as being...