I have a 73 Dart Swinger with a 318. It needs a rear main seal. I hear you can replace the seal without removing the motor. I am not worried about the seal replacement its removing the oil pan. Has anyone tackled this before who can give me some suggetions?
Will the stock 5/16 fuel lines provide enough gas for a modified 318 with 350 or so HP, mild cam, mechanical fuel pump, and 650 Edelbrock carb?
I was thinking about upgrading to 3/8 lines but I do not know if it is necessary.
Any suggestions or opinions?
Help!!
I have a 1973 Dart Swinger 2 dr. Hardtop. I replaced the windshield and ordered a new set of windshield molding clips. The old clips were damaged and filled with sealant. The kit contained 23 clips. They were all the same except for four of them. Does anyone know where the four odd...
Has anyone used these products from Mopar:
--- Duel Purpose Shift Improver Package or
--- Performance Shift Improvement Package.
If so: Are they worth it? Are they easy to install from under the car?
My Dart is not a race car, just a car to have fun in.
1973 Dart/ A904/ 318
Has anyone adjusted the kickdown band and low-reverse band on an A904. It looks easy per the repair manual; however, I know how things really work.
Is this something I can do at home or should I take it to a transmission shop. This adjustment is recommended a part of...
1973 Dart/ 318/ A904/ 8 1/4 suregrip rear:
When I hit 55 MPH there is a shrill whine from the drivetrain. It only happens at 55 MPH. It is quiet up to 55 MPH and goes away at just under 60 MPH. If I hold at 55 MPH the whine will go away after about five seconds or so. If I accellerate hard...
Does anyone know how to replace these?
The guy who changed my windshield bent and broke some of them and now my trim does not sit flat. He basically glued the trim down with window adhesive. The window adhesive is everywhere. Its a huge mess.
And, where can you find new trim clips?
And...
I have a 1973 Dart with the original 318. It has 46K miles and it purrs like a kitten; however, the heads need seals and valve guides. I was thinking about replacing he stock heads with a set of 302 heads. Will these heads bolt right on and run without any modifications other than plugging the...