Recent content by wishihadahemi

ok, so the 405 has a different pin height, lowering the piston..... i didn't check all the numbers, thanks....but that's what i want is tight quench top and bottom with fuel mixture compressed only into the chamber. that's what is making these modern LS , Hemi,ect..... make power. "The keys are...

block is decked for zero at flat part of piston. the piston i think i need is a Sealed Power H405CP , it has the double quench but the dish in the center is not enough. my block is a 74 360

I didn't explain that right , i have used the 232 pistons for the X and J heads in the past , they have the bump for the open chamber/ dead ..... wasted space that the step takes care of and forces the mixture over to the combustion chamber to be reacted . I'm wanting to switch to the EQ Double...

part number of .040 over size with +20.5 dish?

first time trying to use EQ heads, best power is made by close to zero deck......or using .039 gasket, i would use .028 mr gskt as before on my other engines with X and J heads with KB 232 Step Dish Pistons. David Crower from Crower Cams (RIP) told me years ago that engines that keep carbon...

putting together a Hobby Stock 360 using EQ 62 cc heads. need the Magnum style double quench dish piston with enough positive volume (more than 20 cc's) to get 9 to 1. It's .040 over, zero deck, .039 FelPro Gasket. Probably a custom piston ??

ok , big difference at the Tappet vs. Retainer......thanks everyone

i want to check a cam w/o any numbers on it when i do Dur .050, thats with zero lash (its a hyd) and when valve opens to 50 then mark deg wheel, continue rotation until valve it 50 from being shut and mark again. that total amount of deg's is the @.050 number? if thats not correct , could...

it's a friends BB Duster with a MSD distributor and box. he just moved the battery to the trunk. it cranks fine, but will not start and run one thing it does is pops off a cylinder as he releases the key to the "Run" position. if he puts jumper cables on it from another car , it fires right...

i have a set of new castings #4772576 cylinder heads heads are bare and un-touched, just as they were shipped to me from Mancini 800.00 shipped. or make offer location Plymouth Co. (LeMars) Ia

pics of new heads

casting no. 4772576 , P-4529269 nib bare 700

i have a set of P-4529269 casting no. 4772576 bare never used cylinder heads. asking 700.00 these are the 308 service head for the crack prone dodge trucks and vans lemars iowa

ok, i'll go to Brewers and see what they can do for me. i'm running a 68' 340 SS/J Barracuda