PCV Recommendations.

seabee said

Thanks for the reply. They are the MP aluminum valve covers. I have punched out the holes and added baffles. Just don't want to start Dremmeling until I find an optimal (quality) pcv.

My setup is similar to yours is except can't tie into the air cleaner because it is a low profile base.

Click to expand...

Understandable.
You might have to just run a decent filter unit for your air inlet in that case.
As far as the grommet for the valve cover that the valve goes into, some of them vary on the OD as well as the thickness for the cover material but where the valve seats is pretty standard.

These are the ones for those covers, and then you can pick out a valve.
The one for the breather/filter unit is cut out if using a filter or cap, or left the way it is if using it just as a plug.
http://www.summitracing.com/parts/dcc-5249642/overview/

One thing I might mention is that the baffles usually make it kind of a pain in the butt to add oil, but if you end up with the cap/filter grommet with the 1 inch ID you can cut a plastic quart oil bottle and sand, file, moto or whatever the threads for the bottle cap off and it works perfect as a funnel cause you don't have to hold it while adding oil.
I have to also pull my PCV valve while adding oil or it burps back out on the valve cover. (because of the baffles being so close to the opening)

Just some thoughts to hopefully make your life a little easier. :D