318 driver - cam change or not?

good points yy1
360 cam
I've had customers try it
not worth the time and effort
Aj posted in another thread today
" But I sure noticed a torque loss at the bottom, whenever I installed a 340 cam. To this day I have three or four of those cams kicking around."
340 or the 204-214 cam are worse than the 360 but same problem
open the exhaust way too early and not much lift for the duration
they come under your
  1. "this one adds some high end but drops low end 5%" (more than 5% late intake closing)
    "this one kills MPG...because" (early open exhaust on the power stroke)


    ReportBookmark
    + QuoteReply
  2. Today at 5:02 AM#82
    22681.gif
    YY1Well-Known Member
    Messages:
    6,387
    Likes Received:
    2122
    Joined:
    Oct 11, 2011
    Location:
    FL
    Local Time:
    3:33 PM
    NewSomething I don't see mentioned hardly ever on 318 threads-

    We should probably acknowledge that we are dealing with two different groups of engines (actually 3 but group 1 and group 3 could be considered similar)

    Group 1 is the 67-70 9.2:1 advertised compression engine

    Group 2 is the 71-84 8.8:1 mill

    Group 3 is the 85-91 LA roller- back to 9.2:1 and with "302" heads

    From all the discussions I read it seems that even that .4 of compression could be a big difference when choosing a small cam for a small displacement engine. Even if it's actually more like 8:1 and 9:1 (I have a suspicion, along with anecdotal evidence that factory ratings got closer to the "true" rating as we get closer to the modern day- IE the LA roller is probably an actual 9.2:1 motor).

    We should also probably discuss what the largest lift is on typical 318 heads before milling the valve spring base is necessary.

    I don't think you can compare ford 302 performance to 318 performance for a given grind. they are wildly different esp in the head.

    ReportBookmark
    + QuoteReply

Page 4 of 4
< Prev1234
Go to First Unread
avatar_male_m.png