Anyone run this Voodoo cam ?

thanks stixx
.004 to .006 makes a big difference
Oregon does give more info than most except those that give cam doc print out
Slantsix64 HR regrind by Oregon cams
Camshaft specs are 260/264 .437/.453 110LSA Oregon Cams grind 1006. Also adding a melling double roller timing chain.

nm wrote OK, just looked it up: ICL is 108 so only 2 degrees of ground-in advance.
Pretty slow ramp cam for a roller... 57 degrees of difference between the advertised and .050" lift duration numbers (203 vs 260). Does not take advantage of the roller.. but it will last forever! The regrind cams profiles there are slow ramps...that may just be the nature of the re-grinds.
Hydraulic Roller Camshaft Specifications (Oregon Cams) roller camshaft grind 1006
.437/.453 lift duration @.050 203/208 lobe center 108/112
dartfever posted
That grind is very close to the original r/t cam mopar sold for the magnum engines. .050" 204/208, advertised 260/264 LSA 114 ICL 109. .458" in .467" ex. Have this cam in my 5.2L dakota with 1.7 rr's. Ported heads, shorties, M1 EFI intake. 247rwhp and consistent 17 city 21 hwy US MPG

slant's cam card is here post 48
318 budget build
and that card says .006