Working on electronic ignition conversion for HP273 dual point distributors

Edfury426 said
I too have the IBS 4013 cast iron dual point distributor and have had multiple conflicting answers from different Pertronics reps over the phone regarding their kits.

I've been told that I need the 1383, 1385, 1385 LM, and twice told that nothing is available that will work on my distributor.

Could you please reply one more time Toolmanmike as to if you also have the IBS 4013 and if the 1383 kit worked well for you? Has anyone else tried this specific combination?

Please keep us posted Valley Boy as to your results with this combination as well.

I have a '67 Barracuda 273 Commando and am only looking for a nice serviceable electronic conversion, don't need anything fancy...

Thanks!

I am awaiting the distributor portion of the conversion kit, I did receive the coil. I will kept posted when I get remainder of kit and install. My only install question is regarding the ballast resistor. There are 2 terminals with 2 wires going to each terminal. Toolmanmike, I think you said you just tapped into the wire coming from the ignition switch. My question is what about the remaining 3 wires did you just leave contacted to the resistor. What color was the the ignition wire. Thanks again for your help !!