Search results for query: *

Oil holes "Down and Out" is how I remember.

I believe OP was interested in what components are involved, not where to obtain them. Evidently Dale's does not by a search I tried. From the '69 OM..........

What's in it now? What are your likes and dislikes about it?

Yikes! Sorry to hear. Hope those stents work out for ya'. No fun when they need to break in! Best wishes! Stay positive!

I used my leftover Volvo-Penta outdrive paint on this old crusty gem..........

Lol...........

:thumbsup: There are several pictures in the forum that show the stiffener in various orientation. If it's solid, it's good IMO. That said............ I did find this picture a couple minutes ago................

The spring in my '69 "HD" peddle set if it helps............

Not sure you can but maybe it's possible to get a measurement from the disc OD to the input shaft spline. 4" and less would be a 9" I believe.

..................

Check the middle of this page. Click the trans picture ...... http://www.bigblockdart.com/techpages/4sptech.shtml I like the MP suggestion of the bell crank being "straight across in any view". I'd relocate as necessary.

Another parts supplier ......... https://www.blackhawkparts.com/

Maybe..........

1-1/2" should be F&D...........

A little easier on the neck...........

ya' lock yourself out.....................

My '69 if it can help. Looking up.......... Your's.......

Maybe get a rough measurement of the current seal depth, the axle lip depth after seal removal, and the new seal thickness for reference of install depth. Don't forget to grease the seal spring so it stays put while installing.

Best wishes on your recovery! :thumbsup:

If it helps at all, my old 440 six pack here has a shaker base. I only needed a slight bend to clear the 2 speed. These other bases would likely need notches for a 440.... The front passenger side should be the tightest for hood to lid clearance due to engine offset.

@ 3:20 in the video you claim the pop was present with the Eddy carb. That kinda' has me leaning toward an engine issue and not a carb issue. Maybe disconnect the x pipe and determine whether it pops out one side or both?

Perhaps a bolt was bottomed out in this bolt hole at some point(?).....

........ https://www.mymopar.com/downloads/mtsc/352.pdf

:lol: Lol, this could have been a Kodak moment. I pry barred the old wallet to purchase a brand spankin' new hose nozzle to replace an old worn-out leaker. It looked fairly decent. Has several spraying features. And....it's not ALL plastic! :thumbsup: Check this gem out! Screwed that...

A couple years ago I was driving through a small town in western IL and caught a glimpse of a '66 for sale. I thought, what the hey. take a look. Went around the block and read the writing on the windshield...............................

Those were std.

What my old ones were if it can help........

I'd just do the MP.

Out of the box. maybe you could expand them a bit with threaded rod and nuts?