Separate names with a comma.
diymirage: Don't know if you ever bought a welder or not but here's a story that might be worthwhile to you or someone else. The story covers...
Hope this helps: Moparts on the Web - Main Index Steering Box Info
You've probably gotten this sorted out already but thought I'd throw something out. Event though they are magnums and aftermarket, pull a couple...
Thanks for responding but I've decided to go a different route, dan...
How much for shipping to 32060 and do you take paypal? dan...
What did shipping turn out to be?
Dan Hughens co/Gerlach 16779 96th st Live Oak FL 32060
would you accept $60 for both shipped to 32060? thanks for your time, dan...
Don't know why so many guys are hammering you on your dual quad idea. Here's a guy on the forum using your setup:...
I just looked up the part number, don't know why I didn't do that in the first place??? They are for drums...
Do you take paypal? Thanks for your time, dan...
The odd thing is that I am an old school Mopar guy with big and small block experiences. I do not remember ever seeing a corroded timing cover in...
Well, finished job. Apparently a corroded timing cover is not too uncommon, as the first timing cover I pulled at the Upull was also eaten thru...
How about an update... After taking off the intake again to inspect, I discovered that the tbi intake runs water completely through its bottom,...
Looking for some info from those who have been there/done that. The issue is an 1989 318, 110k miles, with water in the oil after head swap....
I agree with you, it's worth more than $36. I didn't figure it would cost that much to ship. Thanks for the reply though. dan...
If you will accept $80, shipped to 32060, usa, I'll take it. Do you accept paypal? dan...
Are your bars for sale? I am in the market for a pair at the right price, dan...
I should have asked if they were for disc or drum brakes? I need for disc. dan...
Do you still have these? If so, I am interested. dan...
Where are you located in Alabama? I drive truck over the road and run through the state periodacally. If you are not near interstates, I would...
Any specs on the springs? How much arch, spring rate, vehicle weight, etc? Also, was your racecar a streetcar or strictly race? Do you have a...
Is it an illusion or is the pic of the small end of the rod slightly discolored from heat? Have you lookied at the wristpin and small end bore to...
I have a picture of one in an old 66 or so Hot Rod book, (5x7 book, not magazine.) It is a 273 with four Weber downdraft carbs and powerpak...
Apologies to everyone. I just reread the rules for ads and saw the one for phone numbers. No intent to bypass the rule, I always use...
First, discs are superior of course but I think your brake adjustment might be suspect. I come from a time where drum brakes were normal and...
Thanks for all the comments. I would like to repeat what I think has been said to verify. I can use any disc/drum proportioning valve from a...
After significant searching, I cannot find if the later proportioning valve can be used successfully on an early disc setup. Specifically, using...
That was a pathetic way to get in your phone# Dan
are these wheels still available? dan...
