Separate names with a comma.
It is not lower, but close. I plan on roughing up the floor pretty good to give it some edges to atomize off. The one I’m running now, the upper...
I have run a 9.5 inch PTC converter that stalls around 3500 on the street for years. Todays converters are not like the old high stall converters...
Easy to make that HP number in a streetable combo. Those blocks are 40-50 lbs heavier than a stock block. It is a very good block though.
I think you have easily met your goal assuming the car is sorted out.
Need to port match it. Clean up inside the runner a bit.
One runner,[ATTACH][ATTACH]
W2’s have relocated ports. Also you can’t run a stock intake casting. X head is it for small block mopar. Getting the casting back after the...
I have a spare ported head but no valves or flow bench.
Going to run a/f meter on both sides and check the plugs a bunch.
Headers will add power, the more serious effort the more power. That being said headers have some issues like they take up a bunch of room making...
Thank you!
Same class if it was a 4 speed.I know the 383 RR, black? This is us at MIR.He’s car 99. Then he goes and tests and runs 11.5 or 6!!!!!![ATTACH]
I looked at Brezinki’s, but on a mopar intake they only go to level two of three and it is a bunch of money. You end up essentially with the the...
I was lucky that day, but I’m a couple of tenths behind a pesky small block 67 chevy II. Any improvement and I can start to taylor the rest to...
I really would like to see an increase in mph. If it shows promise, but I lose to much in the 60’ I can pull the 4:10’s out and borrow more gear....
Track to begin with, I have AFR gauge to get it close and keep an eye on it for going lean. The good thing is it will SMOKE if it has a vacuum...
Current intake and plenum I’m running and can always go back.[ATTACH][ATTACH]
Two classes running this style with subtle differences between them.SuperCar Races. American Muscle Car Racinghttps://www.fastdrags.com/
Any internal modification is allowed. Well no raised cam’s or decks. No nitrous. When done I will post pictures of a stock intake and this one...
This is with plenum under it[ATTACH]
I will inset flanges into the stock sealing surface and use the original intake bolts/boss to sandwich the plates to seal it.[ATTACH][ATTACH]
It should give me 6” from carb base to plenum floor. I have made the runners which taper from 1 1/2”x 2 1/2” down to felpro gasket size.[ATTACH]
The holes will be removed. This is the plenum the runners will be straight off the plenum.[ATTACH]
I made the new plenum which bolts to and will be epoxied to the bottom to seal it to the underside of the original intake. I will totally seal the...
[ATTACH] So I’m tired of paint and body work and it’s to cold to spray color now anyways. So I have embarked on tackling the intake on my car. I’m...
I bought a dressed 408 from Blueprint in 2008? I have abused it to no end and it has performed fine. I’m still running the block/rods/crank at...
My 68 original 340 has the tabs on the front passenger side gor the alternator
My heads and intake are ported to use the felpro 1213 Contents Lower Intake. Manifold Gasket Material Premium Quality Composite With Printoseal...
Yes, I plan on pulling my pump this winter to check. I just don’t want to pull the cover if it is getting worse. The pan gasket isn’t leaking for...
Does it have a hot start issue? You are heating your fuel with the fuel line sitting against the heater hose.
