Separate names with a comma.
Ryan, I'll see if I have one of the originals we sold so many of and if not, I'll find a CD and burn another one or two. Tom Hand
These are the ones we tested and recorded, for the most part. Some are not on the CD as we did not have them in time to record them.. I have...
Ryan, you need one of our CDs we made with muffler sounds! Silent Power.
Cruze, try a set of these. 2.5" in and out, offer inlet, center outlet and they should quiet it down. Walker Quiet-Flow 3 Mufflers 21856
Eaton made mine. Stock plus about one inch. Nice fit, perfect ride (for stock), great assembly and longevity.
Thank you Mr. TJPATTE Private message me Jim and I'll get info from you.
52119168 2.5 L 30RH 4WD, YJ, XJ, LU My factory books show a 94 to 96 Jeep uses this number very close to your...
I built one of those a while back! Bushing was worn out so we water jet cut a new urethane rubber insert for it.[ATTACH][ATTACH][ATTACH]
CCAS, I still have my OEM 340 tailpipes for 1969-1970 340/383 A body. And the front section for the 69 Barracuda.
Waldron's makes 409 st. st systems. I recently bought one for a 71 Satellite 400 . At least they used to.
Bryan the 17748 is a 20" body muffler and stock uses 18" ones. I shortened the inlet bushing 1" and then welded three bolt flanges to the outlet...
It should be fine!
Bryan use the 17748 longer case Dynomax 2.5" versions and they will have virtually no drone and sound great and are quiet and flow well. You have...
It'll be little noisy but not bad on the slant six.
RRR, the Ones we tested for the data in the chart (17513) are 20" long ones and they are quieter for sure than the shorter 14" case ones. And,...
Depends on size, outlet and inlet configuration, and what car and engine they are on. They are louder than the Wrapped UltraFlows and have less...
Yes, a lot!
Here is the set that is now on the VOE "Humbler" GTO from that 1970 commercial. It is almost restored and soon will be on the road.[ATTACH]...
They are 10 dBa louder at idle, open, when measured at 20 feet and idling around 900 rpm. They are around 8 DBA louder at other engine speeds....
Yes sir. Got lots of trees up in the house and due to the virus, lots of neighbors had time to put up lights. Very pretty!
I built them for my car Sparky. They are 2.5" in and out, offset in, center out, and they have 19" long shells. They have all 304 st st...
I built a set of vacuum actuated ones for my Father-In-law's street rod. Did not leak too badly and still don't BUT they are behind a mild 327....
Sparky, these mufflers in my avatar are on my 69 340 S. Not a loud as open headers but sound very nice when open. Very quiet when closed.
You are sure welcome. I have a good book that talks about Torqueflites and has lots of numbers and photos!!!
Sam, 2829314 is a 67 slant six/318truck.
Dr. Charles, I bet I have what you need: 3" Dynomax VT mufflers. We have set on a 408 68 Barracuda and you'd be amazed at how quiet they are for...
318 is not the same but the 383 four barrel is. Here is the copy of my 1969 Parts Book.[ATTACH]
My turn to guess. I think it is one that builders made using the FWD Chrysler cores. Not sure they were very efficient as most street and some...
GSX , I have no shop but if you removed it, I'd be glad to help you check it and reseal it. All my pals in the shops have retired or sold their...
A site? No but I'll send you a note on the private messenger.
