Search results for query: *

Now now children.... Some of us old cantankerous farts forget that not everyone knows what we know. So to us some things seem too obvious to need to be asked. Sometimes our delivery is a bit abrasive as well. Perhaps we can all try to be a bit more like 2000 grit than 80 grit and also at the...

The 67 273 standard cooling is under driven the wp pulley is about 6.75 and the crank pulley is about 6.5 If you can get a 6.5 and your crank is 6.5 you will probably be fine The other thing that was done is fewer vanes on the water pump, when the speed was increased. Check your FSM, I...

It looks like a 67 A Body Radiator The top tank is slightly different in 68-69 3x 67 top tanks. Original rad from my 67 dart 273, non AC, with CAP. (Known recore) The solder-on tag with the part number is long gone but it should be 2785 970 (2 cores, the tubes are narrower) 67 273...

In 2017 I bought an o'riley brand battery 3 year IIRC It is still running strong in my dart. I put about 1000 to 2000 miles per year on it.

If the car is sitting on all 4 wheels and one t bar is fully loose then something else is keeping it up. Put a jack under the loose t bar lower control arm and jack it up. If the car raises them either it is at full bump and hitting the up bump stop or something is seized

6 faces. (Or is it 5?) Not really a way to mis clock the bars.

Assuming your shop floor is relatively flat you could test this theory out by supporting the body on jack stands, if it is twisted it will show up. I have a 67 dart stripped down and one of 4 jack stands needed shimming. Might be my shop floor cause it was only a fraction of an inch. If it was...

Can you move the suspension on the side with the t bar loose through its range of motion? Maybe it is frozen? Does the car have a sway bar?

I had a door mechanism on my front door of my house. Over time the part that retracts the bolt had worn down (worn a grove) and the lever got harder and harder to open the door. To the point it would no longer open. Thoughts... The pin on the back of the outside button might be worn down...

The rear springs can effect the front left right lean.

Did this just start happening or has it been getting harder to open as time has gone by? Have you changed anything in the door? If you push in, pull out ,lift up or down on the door while pushing the outside button does that change how the door opens from the outside?

Does not seem excessive. But for a test you could try reducing it to 5 or 10 just to see if it makes any difference.

Where is your initial timing set. A lot of initial timing could exacerbate the problem But my bet is on the trunk mounted battery wiring

I'm not aware of other than GT rocker trim. It's about 3 inches wide

14x4.5 sbp wheel 155 x 14 tire Also sits flat in the well. BUT it is just under 24" OD and the 245 x 60 15 is 26.57. If used on a suregrip the clutches will be doing a lot of slipping to go straight Firestone F560 Radial Tire | 155R14

Any update on the hose?

Steve, Do you have suregrip? If so be sure whatever tire rim combo you get is the same outside diameter as your rear tires. Unless a 14" rim won't fit your brakes the rim / tire size is immaterial as long as the outside diameter of the tire is the same as your rear.

Here are photos and dimensions from my 67 Dart OEM link and the part number of the OEM repo links installed. If your OEM sway bar has these type of mounts to the frame and looks like this the links are probably the same as 67. Approximate center between bushings 4.5" Washer to washer...

Unless you disassembled the 2 heads or put the 100 mph number plate on the 120 mph head Not much you can mix up

Wouldn't you?

But you are probably getting what is advertised. He has a reputation to maintain

I would check on the registry for any GTS you are looking at. If it's there chances are it's real

The front most bolt is a carriage bolt (very thin square section compared to a standard carriage bolt) The rear bolt is a standard bolt

So it sounds like you changed from a 100 mph to a 120 mph speedo. Was the 100 speedo accurate? If so the 120 speedo may need to be internally calibrated. You can verify this by driving a known distance. The longer the better! Recording the odometer at start and stop. If the miles are very...

Would you post a close up photo of the center hole of both perches on the housing

Does any of this info match the car? From the GTS registry https://www.gtsregistry1969.com/ Only 102### car LS23P9E102***: GTS#465: ##OWNERSHIP UPDATE## 7/4/2022 : GTS # 465 is now residing in Connecticut under the care of Steve K. Steve bought his GTS from a Classic Car Dealer in the...

How about some photos

End links? Are you talking tie rod ends? Or The rubber bushing on the strut rod?

Be sure to get the restoration type. They have the proper flat in the bottom of the U. Also be sure you get the correct width. 7 1/4 uses smaller 2.5???? Wide, 8 3/4 use 3" And the correct length Mancini Racing 7-1/4 Axle Housing U-Bolts

Look at post 4 Product Review: A100 Fuel Sender For 67 Dart