Search results for query: *

:lol:

X2 plus it looks like one exhaust valve is burnt.

bro, those 920's look tore up from the floor up. if you wanna keep it on a beer budget, snap on those 675's and ship it. there's no telling what could be wrong with those 920's-- janky guides, wasted seats, bad deck, cracked, and on and on. i wouldn't run those without a hot tank, mag check...

Pm sent

I have a dark green one.

Man I need to go back to sleep!

No advice, but watching and hoping for the best for you.

New video by Mitch “Mekong Mitch” LeFevre

Well it is 12 o'clock somewhere!

I believe the Magnum manifold is a 100% drop in.

Well the least you should do to them is, do a garage valve job on them, to at least clean up the seats. You can get a hand drill operated gizmo, and some valve grinding compound and do it. Look up "Valve Lapping tool attachment", on E-Bay they're cheap, and work great. Clean them up good, after...

And then there's Canadian Tire Motorsport Park near Bowmanville that was called Mosport a few years back. Working this weekend so couldn't go... :BangHead:

I'd say it's time for a refresh at the least. That #6 compression is definitely out of range, as is #8. I would suspect #8 is probably getting oil in the cylinder. What kind of rings did you go with, Jack?

My argument would be it depends on what you're doing.

That's how it was with the gals in school.

Grab a heini.....

Only 1400 here...kkkkkkk

Way to early morning to all.

Loose is fast.

I bet most folks will argue that the 920 heads are better, because they are closed chamber heads. I think they'd be great from what I read! Here's the deal, though: I just picked up these 675 heads from a FABO member last Sunday (in exchange for a bottle of Jack Daniels). They were rebuilt...

If the engine bearing clearances were set to factory spec 160 will exacerbate a tight new engine and temp. I have heard of overheating due to ring gap being too tight. If it overheats without a thermostat and with a thermostat it's not the thermostat.

I'm sure it's the fact that you're running a Chevy engine with Ford wiring in a Mopar vehicle. It's probably got a little something to do with it being mixe years from 1930 all the way to 1980. If you don't get the hint, maybe just maybe you could tell us what the FRIG kinda car you have and...

Ouch. Would pull the plugs and bore scope. The pressure numbers could be all over the board due to the valves not fully seating from carbon buildup. Would for sure pull the valve covers, give the valves a slight tap with the dead blow as your working through the cam timing to close the...

That is how you adjust both axles from one side... adjustment from the side with the adjuster pushes against the button, which pushes against the end of the opposite axle.

Good point, I'm pretty sure I installed one in the 273 to lower temp now that u mention it.

180 stat is too high. I run a 160 which my 340 LOVES running in the 160-170 range…

Energy Suspension makes a bracket/insulator set. Uses the three factory bolt holes and adds a fourth (easy to do). You need the bar diameter to get the right insulator.

Wondering about manifolds for my '69 dart 360 magnum. Manual steering, column shift for now but may convert to floor shift. I am wondering whether it will be possible to run a magnum manifold on the driver's side or whether I should track down a 340 manifold. Of course the other option is to...

The best vapour lock additive is to get rid of the mech fuel pump & use a Carter elec pump mounted near the tank.

DMT sells Stainless ones!