Search results for query: *

I didn't realize they were built right onto the gasket itself.

Thanks for the info everyone. I use the high temp wire protectors that slide on anyways. It's nice to know they are out there.

I felt them but they didn't feel like metal. Too bad they aren't re popped.

Casting numbers should be lower LH side of block above the starter

I saw an engine on a 66 barracuda formula S at the Indy Mecum auction last week. It had 2 hard plastic trays that sat on top of the drivers manifold that protected the spark plug boots from heat. Has anyone else seen these or know where to source them? I've never seen them before. I should have...

Yes I am. Please let me know. Thanks.

I am looking for a nice working door lock set for my 65 Valiant with a key or keys. Thanks.

Turns out the situation was strange. I changed the ballast resistor with the same results. I ohmed out my resistor and it was the same as the new one. I checked voltage at the resistor with the key on and had nothing. Checked my choke wire and alternator and had battery voltage. I went back to...

Reviving an old thread because once again this forum has saved my ***. I have been working on my old dodge for several months. Went to start it, engine cranks and dies when the key is released. If I crank it and barely release the key enough to release the starter it runs. Of course tons of crap...

I know it's a long shot but I'm looking for a torque convertor inspection cover for a 518 trans. I removed a 727 trans from my 75 D100. I assumed the cover was the same but it's not. Thanks.

67dartgttgo, How's your swap been holding up? Have there been any changes you had to make with your setup?

Thanks for the replies. I have a purchase in the works.

Pm'd you

I'm putting a feeler out for an 8.75 "A" body rear axle housing. I live in Martinsville, In. just southwest of Indianapolis. Would prefer to pick up if within a reasonable driving distance. I have axles. My axle tube is bent and haven't had much luck finding someone who could straighten it for...

Thanks, I actually found the one for my car in a box in the trunk.

Check out this thread. 65 glass install . I followed RUSTYRATRODS suggestions on post#6. " I don't want to steal Rusty's thunder" Worked out good. Lots of soapy water and the plastic sticks from Amazon . Start on the bottom and work your way around. Don't work up both sides and try to finish...

All done guys and gals. Got a couple of sore thumbs but it's all good.

Times are tight. Had to let my film crew go.

It's in. Just gotta tackle the locking strip now.

Quick update. I am installing my new windshield today. It measures .25" thick

Thank you!!

I've got a 904 trans that's been on my shelf for 10+ years. Will someone please tell me what it came out of? Not having much luck searching the web. Thanks in advance.

Sold. Thanks fabo!

sale pending

bump

Sold. Thanks FABO

Thanks Rat Rod

That looks good too. I thought about adding those lights. This is the only old car I have that will have working reverse lights.

Putting my 65 wagon back together. When I bought it someone had made some crappy taillight lenses out of red plastic. Original taillights were long gone. Wasn't much of a fan of the original taillights anyway. I decided to switch them to the Australian valiant lenses and came up with a...

$110 + shipping from SE Michigan. Box weighs 9lbs.