Search results for query: *

I don't think the remote mirrors were offered in '65, I think they started about '68.

What PBR said, read the instructions until you can recite them. One minor screw up and the block is an expensive door stop.

I run a motor plate and a mid plate, I use the later poly through bolt transmission mount and have had no problems. Just remember, my car is race only amd leaving on the trans brake at 45-4800 RPM.

Get out the volt meter and the power probe and dive in.

A little JB Weld, some duct tape and some polishing compound and you're back on the road! LMAO

In today's age, everything is driven by the bottom line. Employers want as much production as they can get with the fewest employees. This is a trend that started with accountants give charge of total profit and loss. When I retired the second time, I was earning the same amount as I was when I...

I'm still digging, most of my 727 stuff was packed away in the very back of a storage area when I began running 904 transmissions.

The 74 hood has a raised line on the hood and there were some scoops made to conform to that versus the flat hoods on the earlier A bodies.

@Hyper_pak may have some knowledge of him.

It is a spread bore carburetor from the pictures.

Individuals may indeed be able to buy them, but according to a dear friend who has been sober for 30 plus years they are earned and are a statement of honor.

Unfortunately, by the time the idiot light comes on it's too late. That is why I put mechanical gauges in all of my cars.

I believe those coins are earned, not given away.

Possibly the IVR Instrument Voltage Regulator. Somebody here makes and sells a solid state version.

I was 14 years old and went with a friend and his older brother to Houston International Raceway in Dickinson, TX. For years after it was shut down and houses were built, you could still drive by and see the timing tower.

@Ken71Twister maybe interested in this.

OP needs to start with the basics to eliminate what he can from the outside before tearing into the engine.

They are of pretty decent quality, you may have to do a bit of sanding for fitment.

Hang the gauges under the dash, keeping the originals.

Look at the wheels on the Expedition used by the police, most of the offset is to the inside.

20* initial timing?

What is your basis tune up? More information would be helpful.

This is another one, "Just because you can doesn't mean you should"!

I don't trust the "idiot" lights on any vehicle. All of my cars have mechanical gauges to keep track of everything.

The article you posted is 24 years old if you look at the dates of the pushrods installation and in service.

I would run all of the protection I could get. Years back when my partner and I ran Super Gas, we ran both. Luckily we only grenaded one transmission and the floor board need hust a little patching, it could have been a "LOT" worse.

Rob, once you get back into the swing of things I need to talk to you about a relay setup for my race car. It may have to be custom built because I'm actually running driving lights in the turn signal holes of the glass front end.

My suggestion would be to start with the basics. A good tune up, making sure the timing is correct and getting the carburetor lined out with a vacuum gauge. Don't inspect the plugs after puttering around the neighborhood, take it out for a highway run and then inspect the plugs at the first...

Chris Alston has a very in depth easy to understand DVD on 4 link. It was a lot of voodoo to me until I got the disc, then easy as pie to understand.

I would put the oil slinger on, it helps to keep the oil from migrating past the front seal. Ask me how I know?