Separate names with a comma.
Thank you moparmaga said better than me. Not a gold member ,cant upload picts.
FOUND THEM. The factory seam filler was covering the bolts. This is the panel below the quarter panel ext,and behind the bumper. Thanks for the help.
On a 72 it is removable. I have all the bolts out but the top two.
Sorry . a 72 dart 2 door h/t
Trying to remove the panel under(behind) the rear bumper. The top bolt goes in from the inside(i can see the back side from the outside). How do...
Agree, on my 72 dart,loosen headers,Jack up engine a bit and it will come out(via wiggling).
Thank you,guess i better get some high build before i epoxy.
OK got the epoxy part answered. Are you supposed to put high build on within 72 hours??. As you can tell i am NEW at this priming thing.
Just finished removing all paint (and small amount of body filler) from my 72 dart. Used 80 grit paper on a da sander. Should i sand with 120,or...
I believe it is plastic. I put a magnet on it earlier today and it did not stick. That piece is attached to the bumper.
There is a ground wire soldered to the outside of the bulb base,did factory do that?
I am thinking ground. I dont know how long it has been like this.
YES power to tail light. The brake element lights when applied,just no tail light
I see no wires moving around the brake pedal when brakes are applied. When i pulled the bumper awhile back there were light (thin) gaskets on the...
Will give a look see!!
The left side WAS first problem. Now both sides have no tail light. Both left and right side turn signals work. The brightness of the tail light...
Just put jumper wire on two different spots,no tail light.(attached to bumper than metal around light frame and tried touching light socket outside)
I will give it a try.
Will try that again(did it earlier with no success).Will try different spot. I even took bumper off to see things better. It is now sitting...
Without brake applied both sides are the same brightness. With brake applied left side tail light goes out,brake light stays on.Right side is not...
OK will check it out. Thanks
72 dart,with tail light on apply brake pedal brake light comes on tail light goes out. Changed bulb same scenario. Ideas??? Opposite side works fine.
Thank you. I will replace asap.
On my 72 dart 318 coil in stock location,removed it yesterday to clean it up. The wire coming out had light oil on it. Pulled it off and saw small...
Thanks to all, will leave it as is .
Just changed oil in my 72 dart/318. Put 5 qts. in ran engine a few minutes waited checked and it is about 1 qt. over full. It has a short filter...
They are cool!! any extra to sell??
I do not have a service related disability and my H/D gives me the 10%. Just showed my dd214.Been waiting several months for a card from VA.
If you are a vet. show your card or dd214 for 10% off!!
Any year. Dont want a rust bucket. Dont mind working on it. Would like it to run, stop, .