Separate names with a comma.
Do you remember what cam was in it?
The closed chamber will also be a benefit.
Some folks cross thru the frame rail and run lines inside the passenger wheel well. I chose not to go that route on a street driven car. I'm not...
Your inbox is full.
Interested in the IMM cam.
Do you have the cam card from the manufacturer?
Will you sell just the camshaft?
Run a bypass regulator with return line, install thick heat insulator carb gasket, make a heat shield for front bowl; the radiator hose cooks the...
Autozone sells a pack of bushings in the HELP section. Buy 2 packs of the assortment and you'll have enough correct size bushings.
I looked a few years ago to buy a new windshield and ended up buying used. If you find a source for new glass please share.
11.8 gives the best MPH at sea level for me. 340 10:1 93 pump gas
at 2250 your at the top of the idle/trans circuit - smaller IAB to fatten
Basicly extend the idle circuit or start the main earlier. Both require...
just add a switch to turn the field off during the pass.
My 10:1 340 pulls 180 amps according to my fluke clamp on. Motor lights off instantly.
I measured my current draw because of wire size; battery in...
The front and back of my 73 Dart Sport have the extra beam.
IMO the 950 carb/single plane has very poor booster signal down low. My 340 runs better with a smaller venturi.
2 years of small block race thread should be enough real world inffo for all who want to put a motor together. 340/360 penalty bore penalty was stiff.
I use Spicer solid non greaseable. Last set I bought the cross shaft was made in Mexico, needle bearings and cap USA. I've never broken one.
1,2,3 shift then lockup will drop the rpm another 200ish rpm. When you drive one it feels like an auto 4 speed.
I've abused mine for a few years. The converter hub cracking is the weak point. Turbo Action modified my front pump and changed the oil pump gear...
72 jet up front should work.
Do you have one of your brothers timeslips?
Thankyou go fish for sharing and 67dart273 for the pdf! My old mags were lost in one of many PCS moves.
Tape a gauge to the windshield so you can figure out what is actually going on before spending a lot of money. IMO a return system is a must with...
Since this thread is back up I'll update a change I made.
I added an additional 1" spacer and needed to change the seal around the cake pan to...
I use it in the gas 4oz to 10gl to keep the intake valve stems from gunking up.
You need to slowly increase vacuum timing and read the plugs with a magnifying glass looking for shiny metal. At steady cruise the primary...
Great video, thanks for sharing. I run an old $50 swap meet MSD analog 6al, mp mallory gut distributor and an Autozone ford style metal stack...
10 is safe. Hook a vacuum gauge up and keep bumping it up and you will find the sweet spot. My 10.5:1 340 with a 236@.050 cam likes 50* at cruise...
True but it will give the OP an idea of wether or not the alt is operating correctly without taking anything apart.