Separate names with a comma.
I'm not sure I'm following. You are looking for a key on power source? and you tapped into the heat/ac fuse? There are multiple other sources for...
One spring is a basic throttle return spring. You can buy these at any auto parts store. The other is a spring on the trans kickdown linkage. It...
If you're asking it's because you are concerned. If you're concerned I'd pony up the money and switch to ARP studs. I have snapped head bolts off...
Look up plastic headlight restoration online. It's pretty much the same thing. Some 1000-2000 sandpaper will take that paint off. Like mentioned...
Please don't put your fuel pump on a toggle. Put in an oil pressure switch, it'll cut power to the fuel pump if the engine doesn't have oil...
Yep like mentioned above you need to connect IGN 1 and 2 together. Otherwise it'll just crank and crank from the key but no start. You will be...
If all the bulkhead connections are clean and the wiring in general is in good working order you're fine. You have a fusible link on the other end...
Relpacing those joints are a breeze, once you start doing it you'll never bring it in again. A good hit with a hammer on the yoke can help with a...
Nothing lasts forever anymore...my ex can confirm that. Things just wear out.
The 318 and magnum are balanced differently. You can use your 318 Torque converter if you use the magnum flexplate. You wont be able to use a...
I got one a few years back and I've been very happy happy with it!I'm not a slant six expert by any means and am wondering? What is that sheet...
Also I would probable get that Transmission "bent nail" fixed. You have to do it eventually and now's a good time since your wiring isn't finished...
You listed a bulkhead bypass? What is this? Just curious. Also you listed the Ammeter bypass. I'm not sure how you made the connections for that...
If its that big of a deal to you then keep a squirt bottle with gas in the garage and manually fill the carbs fuel bowl through the vent. Voila...
I've used a head unit with a USB plug that'll play my phone and charge it in a couple vehicles. I have mounted them in the glove box and left the...
What is that fancy end?? I've never seen that before! Genius!
I put mine away when they start salting the roads and don't touch them until it's rained a good 2 weeks to wash all that salt away. I just let...
I think you'd be suprised at how a 360 will feel with such a light body.
If your idle is really high it'll bang into reverse also. Just an extra $0.02 Good luck
if your timing is way off it'll cause an increase in temp.
I'm with AJ/FormS I always leave mine on the loose side.Did you make sure you adjusted those inner ones correctly? The center has an intake...
Hmmm. I have a 66 slant 225 and I did not have a coolant passage there? Also don't snug those bolts up too much, they pretty much float there,...
Yep, ground for the starter relay.
I'm confused at how the trans shifts for a "test" with the KD disconnected? Is it controlled by the governor?
Try putting it in N for awhile at stoplights or from Park. Maybe the pumps going out.
Yes the 3 prong neutral safety switch on an automatic sees continuity on the outer two prongs when in reverse for reverse lights. It is grounded...
I like Holley's as well if you're looking for a new carb. I've even gotten the refurbished ones (directly from Holley) and had good luck and they...
I've used these firewall connectors on Mopars in the past with success.[ATTACH]
You need to consider how a vehicle is driven also. Lots of short trips and the oil will degrade a lot faster.I have a 5.9L in a 2001 dodge ram...
I had trouble too. Keep heating and beating it. Mine eventually came out.