Separate names with a comma.
Yes it will bolt up to your 340.
I agree that sounds high for that rear end. I just sold one with 391 gears,sure grip,moser axles and willwood disc breaks. Had maybe 500 miles on...
Nice looking setup. Are you using a fuel cell? Just asking because with mine I found out that rear cover won't fit with a stock tank.
I use a blanket. They are fairly easy to install. I would recommend using a good trans cooler.
I have the same dip stick. It will not fit. As you said the peice that bolts to the trans is to long. I ended up cutting and welding pieces to...
I have one and like it. No problem with it so far(4 years).
I have mine on the side of the pan.
Thanks mopowers, I didn't know that. Learn something new everyday.
I didn't think you could buy 373 's for a 8.75. I think 3.55 is your next choice.
I use the lokar linkage on my cuda. Easy to install and works great. Everything you need comes in the kit. Properly the cheapest place to buy...
You can hook them up on both sides but only the passenger side is right.
Are the trans lines hooked up on the right side of the trans? My buddy hooked his up on the other side and that is what his did also.
Thats what I have been told. Heavier cars will like a 3spd more.If you decide to go that way pm me and I will give you a screaming deal on a...
I think unless your running a big converter(3500+) that will work just fine.
I'd check with strange or moser on a complete new rear end first. Time you buy your junkyard rear and have it cut down and new ends welded on and...
I have that trans behind my 499 stroker. Has about 75 quarter mile passes and 2 k street miles on it. No problems so far. Must of just got lucky.
Is it a race car or street? Or both.? I use a TCI built 727 behind my 499 stroker and have had no problems. Street driven when nice and has about...
Unless the converter sprung a leak, (I doubt that) it has to be the seal.
You can also have the old axles drilled and tapped for threaded studs.
BP27 is right. If you are going to go bigger and have a driveshaft made, the 1350 is bullet proof.
Very nice stuff. I'd like to put a altercation suspension in my 67 this winter.
Your dart sounds like it will be real nice.
They are the same length. My old drive shaft from the 8.75 days fit.
gdonovan your right the reverse rod is smaller. Contact Bewers performance and they will hook you up with the proper rods.
I use a B&M deep pan but its close to 5 inches deep and yes I had to use a spacer to drop the filter to the bottom of the pan.
Have the best driveshaft you can afford built. Its cheap insurance
3:73's in a strange S60. 28 inch tire