Separate names with a comma.
I figured those would be a joke.
I have also looked into using a factory projector unit and butchering a cheap ebay clear housing to install it
Headlight RelaysWhen I do the upgrade I am planning on getting one from Rob:http://www.forabodiesonly.com/mopar/showthread.php?t=216514Also...
No problem glad to help
Here ya go
3rd pic is lookin at it if you were the master cylinder
Right behind the battery tray on the inner fender about the same level there are bolt holes for it
They look just like factory harness as they are a complete factory replacement an few pics on this page
It is a factory replacement and looks just like factory
Check out http://evanswiring.com/catalog.htm
Best engine harnesses out there and direct replacement
Have one for the Charger and may end up...
To get access to gauges you must remove the entire cluster from the car and then unscrew the 10 or so screws from the back of it. I...
Low Blinker Fluid?...LOL
That looks to be the plug that plugs into a switch for the map light that is located on other side of dash under the glove box
When you open the door and is on for 60 seconds or so
The light is part of the A01 Light Package and is supposed to have a cover on it that shines the light directly on the ignition switch. When tryin...
I plan to replace the 3 smaller gauges on the left with new gauges that have same function and want to move the 3 cluster gauges to the dash where...
It isnt factory not part of the light packageWas added later.
I have used mid 80s GM ones with no problems
60 amp would be fine but run the headlights on a relay and the fans and will have no problems
Thanks for info Joe.
Will be doin this soon
Evans Wiring is very nice harness as well
Front and rear were lit on 68 not 69 but then again on 70s.
Forgot to take pics Hemi.:oops: Will do tomorrow for sure.:burnout:
Whats up bud? I will grab some better pics of what they look like in the mornin
Check fuses in fuse box. Might have blown one
This dont work. Just tried it on my dads 68 charger and it didnt work at all
Yep Thats what I was sayin
Oops didnt finish typing threw in a brand new group 27 and it turned over other battery had voltage but not amperage
Dropped the Group 27 battery out of the charger into it and it crank other battery had the voltage but not the amprage
The only problem is that ALL the cables except a few on the relay a brand new
But I will investigate and try to do more to get it to work in the...
That is it exactly
The wear on the starter is in the middle to the end towards the front