Separate names with a comma.
What would be the "ideal stall range" for my set up? I have ordered the parts, but they can be returned.
I was interested in hearing what PTC had to offer, but all they did was send me a reply saying they had a TC for my set up. I e-mailed them back...
The previous trans was a stock rebuild/stock TC, with no shift kit so I will have now have the chance to see for my self the difference between...
Agreed Rusty, I have always gotten great advice and tips here.
After 3 nights of banging my head on the keyboard searching for a converter, I finally just decided to go all TCI to try and preserve any hope of...
I filled out their online spec sheet, but i'm not looking to spend over $250 on a TC and I doubt theirs will be in that range.
I found this chart on the webFactory ConvertersEngine ................ Diameter ............. Stall-Rate
* 225 ...................... 10.75"...
If the tires are the same size on all for corners try swapping around to see if anything changes
Does the drive shaft have the C-clips on the rear U-joint that keep it centered in the pinion?
Have any machine shops near you? I used a local machine shop to set mine up and they did it for just under $250 bucks.
There also this book that's...
Are there any charts or apps for choosing a torque converter that allow you to input engine size, rear gear & tire size, etc.?
Check out AMD's web site they sell the brackets your looking for.
Body Components - Floor - Console Brackets
You could make it out of some scrap sheet metal:thumbsup: