Search results for query: *

Hey FABO, Help Please! Well it seems the inevitable has occurred: The mechanic is convinced the Brake Booster is dead! So where do I go to get a factory correct booster to replace my dead one? I saw a comment on FABO about a shop in California that does rebuilds on them and sent an email but...

I had a front disc brake conversion done on my '68 Dart and the brakes seemed OK for a while, the guy who did the swap pulled my Distribution Block and plumbed in an aftermarket adjustable Proportioning Valve (which started leaking almost immediately). I recently bought a new Disc/Drum correct...

Hi FABO members, I'm trying to put the original brake proportioning valve back on the car. I have a vacuum assisted 2 chamber M/C that was powering 4 wheel drum brakes on small bolt hubs. I had a guy switch out the front drums for a small bolt disc brake setup I ordered online and he installed...

Do I still need this old ballast resistor? Since I seem to have a nice new one that was installed with my Pertronix distributor upgrade. And what is the little black box with the red label on it?Aftermarket Ignition control possibly (ancient)?

Hi Fabo, Does this look right to you? Didn't look this way when installed. Does this indicate worn bearings in distributor!? Worn drive gear? Help please.

Hi FABO, I'm sure it's here somewhere but not sure where to look? I need to pull my windshield for painting the car and I'm not sure what to do about the gasket and trim. I think I have an original gasket with aftermarket trim that is sort of hokey. Any hot tips on where to get new old stock...

Hi FABO, Is it possible to swap out a cracked dash pad, or do you need to find a donor dash that is mint with uncracked pad? I'm looking at buying a dash with nice "chrome" detailing intact and better heater controls but a cracked pad for my '68GT. Advice requested, links appreciated...

Hi people, So I have an old wooden boat that has suffered a structural failure. It has a pair of running 1968 or so 426 Max Wedge motors in it. One is counter rotation. Any idea of value or whether anybody likes these motors or blocks anymore? Should I be posting on Cbodiesonly.com ...

Hello FABO, Does anybody know if the '65/'66 top will fit my '68 dart GT? I found a local place with dead stock still in a box for $150. Would love to snap it up! Thanks folks!

Hi People, Does anybody know if the doors off a '73-'74 Dart/Scamp will fit on my '68 Dart convertible? Some bozo tried to roll my car away from my house and hooked it on the neighbours car! Duh... no power steering when the motors not running, and it isn't a Toyota corolla! Thanks for the...

Hi folks. I had my 1968 Dart GT convertible's engine rebuilt in '08 (I was super busy and cash poor at the time, and the internet was useless back then for parts). It had a 273 with a factory 2 barrel carb. The 273 pistons available in Canada were going to add something crazy like $1500 to...

Hi folks I have 2 questions, 1- I have a '68 Dart convertible and I am showing a fair bit of rust where the door frame joins down at the rocker panel (both sides of the car) . Can I chop out this section of sheet metal from a '68 hardtop and use it to replace whatever has gone wrong on my car...