Search results for query: *

Hi folks, I have a 1966 Barracuda 273 2bbl, and the linkage rod for the auto choke is not the correct length,...so the choke doesn't open all the way once the engine is warmed up. I don't know if this is the original carb, but I don't think so. I discovered this problem during a full engine...

Hi folks. I have a 66 Cuda with 14" wheels. I've found the correct hubcaps for a 67 cuda w 14" wheels. Is the lug spacing that same for these 2 years? I have a chance to buy the 67 hubcaps with the 5 holes for the lugs to stick through, but I haven't found any lug spacing dimension for either...

I am restoring a 66 Barracuda 273 and am having problems with the AC controls. Here is what I've checked so far: - All vacuum actuators, and AC, Heat and Defrost doors are working when hooked up directly to vacuum lines. Push buttons move freely in and out. Heater valve control cable and valve...

Hi everyone, I am looking for a single terminal NSS for a 66 Cuda 273 2bbl 904 trans, but I haven't found one yet. Is it possible to use a 3 terminal NSS, connect only the middle terminal, and seal the unused outer terminals? Thanks

Hi everyone, I have done a few searches under different phrases and can not locate a thread to help with following: 1) Where can I find the specs for the original alternator for my 66 273; 2) I want to upgrade to a higher output alternator due to additional accessories (sound system, etc - car...

Thanks to 67Dart273 and also input from the Electrical and Ignition Forum, I successfully converted my ammeter on my 66 Cuda to a voltmeter in about 3 hours. I used the guts from a Sunpro 8215 Voltmeter and mated it to the face of the original ammeter. It took a little time, but mostly just...

I have done several searches for and gotten good info on wiring harnesses, but have not found any info on a company called "Keep it Clean" http://www.keepitcleanwiring.com/. Had anyone had any experience with them? This will be my first re-wire job of this magnitude. Your comments and...

Hi, I'm new to FABO... I need a jack for my new 66. What Mopar cars used a jack that is interchangeable with the 66 Cuda? Thanks